What do you replace a Benchmark with for 24/96?

Fishwater, Bel Canto DAC2 surpassed Benchmark in my system. All Zen cables as well. It sounded smoother, much smoother than the Benchmark and went deeper in bass. Fuller sound overall as well. Needs a good digital cable(don't be cheap there) and a good power cord(Audience powerChord worked wonders on this dac). Never sounded bright with my B&W N803 speakers. Check out my system for components.

I find it interesting that all the other hi-fi sites claim that this or that flavor of the month off shore DAC far surpasses the Benchmark but most of us in Agon don't seem to feel that way. I am curious about this new generation of low cost DAC's but don't know if they do in fact pass the test.

My other question is regarding the non oversample or upsample DAC's. If I am not mistaken it seems they will play the source as it was recorded without up-sampling. So, does that mean it will play a 24/48 recording as such & a 16/44.1 recording as it was recorded or will they truncate everything down to 16 bits? I ned a DAC that will play 24 bits as 24 bits & 16 bits as 16 bits.

I just purchased an Electrocompaniet ECD-1 and am stunned with the results in my setup. I found the Benchmark to be Analytical and thin sounding.

I picked up my ECD-1 here on Audiogon for $1095.00. When used with an Audience PowerChord, this DAC is hard to beat. Good luck!

Chris

Why don't you just get a cable made up to go from RCA to XLR and use your XLR input. There are also adapters you can get for RCA to XLR. Keep the Benchmark.

Benie, I have been thinking that lately but I am also looking for a way to warm up the sound a little. The Benchmark sounds a little cold vs. the Onkyo but the Benchmark is certainly more dynamic with better impact. If I could get that but with a alittle tube sound I would be in heaven.