What's better, one conductor or two conductors for an RCA interconnect?

So I’ve inquired about one conductor versus 2 conductor as part of an RCA interconnect. There has been a substantial response from very very smart people.

Unfortunately, somehow the brilliance is having trouble leading to a point where someone can understand what is being said. brilliant people herein don’t really do a very good job explaining things Beyond extremely technical jargon.

This thread of information is a testament to how challenging it is for brilliant minds to communicate in a manner that can be understood by us average mortals. Truth be told this discourages people and is an unattractive aspect of this hobby of sorts.

Do these really brilliant people know that most people reading the comments have no idea what they’re talking about. It’s really really hard to understand.

I have always considered True genius to be the ability to explain a very complicated situation to the masses. Otherwise what’s the point.

@atmasphere AFAIK we should write symbols of units named after person with capital unit letter V, kV, A, kA, kHz, kW etc. but spelled out units with lowercase : volts, amperes, ohms, watts.  Multiplier doesn't change that, so it will be kilovolts, kiloohms, kilowatts, kilohertz.  The only exception is when unit contains two words like degree Celsius.   

 

@kijanki I try to always use caps in the spelling too.

@jumia Look at it this way. If the signal is passing through the shield as it does when only the shield and center connection is present, then the construction of the shield and any noise to which its subjected to will affect the sound, some of it possibly in the form of added intermodulation distortion as the noise is impinged on the signal.

When the shield is separate from the signal this won't happen so it sounds better.

The actual technical description is more complex as you know; this is the Cliffnotes version.

@atmasphere AFAIK we should write symbols of units named after person with capital unit letter V, kV, A, kA, kHz, kW etc. but spelled out units with lowercase : volts, amperes, ohms, watts. Multiplier doesn’t change that, so it will be kilovolts, kiloohms, kilowatts, kilohertz. The only exception is when unit contains two words like degree Celsius.

Big Volta’s “V” is for DC Volts.

little Volta’s “v” is for AC volts.

Back to the OP’s question…
When a 2 wire and shield cable is used with an RCA it can have the second wire soldered on the “negative”, the positive, or left completely off.

(On an XLR we would solder it to the -180 side.)

It is kind of like 1/2 a transformer, if we look at it like a twisted pair, so I would suggest that one attaches it somewhere. I use the negative side, but the center pin seems like a valid choice.

@jumia

Simple answer to your question is it depends.

There are two standards for RCA. Single ended RCA which uses one wire for signal (the inside pin) and usually is shielded (the outside ring) but the shield is not required for functionality.

The second standard is Differential input RCA which is balanced like XLR and uses two wires to send signal on wire one and inverted signal on wire two. No shield is used.

Both cables will work on any equipment but generally, you will get better results using the correct cable with each standard.