when do you replace capacitors?

The silicon grease will dry out and causes the transistor body to come into direct contact with the heat sink and shorts out the transistor and may cause a cascade effect with the other output drivers. For TO3 type metal can transistors there is a rubber or mica, or really cheap plastic insulator between the transistor and the heat sink and silicon insulating grease is applied between the device and the heat sink. the cheap insulators will crack causing a short to the heat sink also. So, I typically take all the output drivers off and replace them with more linear better transistors and replace the insulators and the silicon grease, check the capacitors for signs of leakage and replace if necessary. More detailed upgrades can turn a very good amp into a really great amp.

enjoy

MinOrl,
What transistors are best and more linear
I have a pair of DNA1 dlx amPs

Minorl, what thermal silicon grease would you recommend best for this application? Would Tech Spray 1977-DP be a good choice?

Thank You

I'll get back to you shortly on this. However, the older transistor amps have very old non-linear transistors. The best of their day, but much has changed since then. Several companies have come through with much better sounding, much more linear high power transistors. It depends on the transistor package. TO3, etc. and whether they are available in that package or what other transistors would fit that meet or better the specs and would sound great. People have spent years swaping tubes and found that there are many that are better than the stock tubes. While it is very easy (although expensive) to do this with tubes, the homework has already been done. But, people don't really swap transistors on newer amps because, hopefully the designer has already done their homework and selected the best transistors they could find. Not always the case. However, in the case of older amps, the field is wide open. If I'm going to open it up and upgrade the power supply or some such anyway, then I check the specs on the transistors and if there are some better ones, I replace them also, rebias, add the threshold type heat sinks if they are seriously lacking proper heatsinking and they are wonderful. I upgraded a bedini 250/250 recently by making two power supplies (one for each channel, including rectifier diode brides, capacitors, transformers, etc.), then replacing the older output and pre-driver transistors with newer, more linear ones,added Threshold type heat sinks, got rid of the speaker fuses, upgraded the internal wiring with Cardas wiring, upgraded the smaller caps to much better ones and this amp seriously blew away most others I compared it with. If I add a regulator, it would be a monster.

I'll get back to you soon on the transistors, but first tell me which ones you have in your amp.

enjoy