Where to put side/rear speakers?


I am adding surround to my system for movies-- Where is the optimal spot to put the side speakers- I will be having two rows of seating- Do you put them between the rows and at what height?- Should they be on stands or wall mtd.? Same question for rears(room roughly 15' wide)- Should they be at the corners ,middle etc. - any links would be helpful- thanks,b.
bgordon
In general, sit in your favorite spot. Look over each shoulder at the side walls, that is the best placement. In other words, just slightly back from 90°. Wall mount v.s. stands and height depends on the speaker.

If you put the back speakers right in the corners you will have the same bass issues that you would have with putting front speakers in the corners. In my room, I put them out from the back and side walls the same as the fronts to start with. Then moved them about a foot wider.
Something else to keep in mind - If you listen to multi-channel music, or want to at some point, sometimes people use di/bipole speakers on the sides, then put direct radiating (traditional type) speakers in the rear. These rear speakers should be used for the multi-channel music.

Also, it may be advantageous to have the rears equidistant to your primary listening spot. Since the 5900 has time alignment for both SACD and DVD-A, perhaps this is of no concern.

For further advice, I think the THX and/or Dolby Digital websites have information on speaker placements.
Bgordon,

The answer for a single row of seating is pretty straightforward. Dolby has a diagram for speaker placement at:
http://www.dolby.com/consumer/home_entertainment/roomlayout.html
You need to click on "Dolby Pro Logic IIx" to get the 7.1 layout.

I have seen a lot of discussion but no definitive answer for side speaker placement for multiple rows of seating. Some say to optimize side speaker placement for your primary listening position; e.g., directly to the sides of row 1, while others say to locate the side speakers part way between rows 1 and 2. Only thing I can suggest is experiment with the side speaker placement.

Having multiple versus one row of seating should not affect placement of the rear speakers. I would follow the intent of the Dolby diagram: not place the rear speakers in the rear corners; not place them close together.

FWIW, my side and rear speakers are mounted 8.5' - 9' above the listening position, due to limitations of room layout, with each angled down and toward the primary listening position. My front three speakers, L,C, R, are at normal height. All seems to work fine.

I assume you have DPLIIx and/or Logic 7 to drive the 7.1 speaker array.

Good luck,
Bruce