Why my DAC will not work with the Mus. Fid. V-Link

Not sure I understand, I cannot define how it locks, it does it on its own, it's an old DAC I bought over ten years ago, it was updated then.
I tried everything with no results.
Thanks for your help
Mario

Even though S/PDIF is a specification, there are lots of implementations of both the driver and receiver. I have seen a lot of different ones having modded transports and DACs for about 10 years.

Some of these are finicky I have found. You may just have a finiky receiver on the Bidat, or the output on the V-link does not meet specs.

Steve N.
Empirical Audio

The OS or music player probably set the VLink to run at its highest spec which is usually 24/192 or 24/96.

The DAC spec says it only read 16 or 20 bits.

So try using the OS/player to set the output to 16/44

Thanks so much guys for your valuable input, it makes me understand a bit more about this issue, unfortunately I do not really know how to change the output to 16/44, I have a Mac computer.
Thanks again
M.

Are you using any custom player like Audirvana or Amarra or Pure Music?

If you are using iTunes:

Look for Applications/Utilities/Audio MIDI Setup

It should look like the screenshot below, except you should have the VLink in the list. Click on the VLink icon

http://km.support.apple.com/library/APPLE/APPLECARE_ALLGEOS/TS3154/TS3154-soundtrack_pro-audio_midi_setup--en.png

On the right, you can set the output bitrate and sample rate. Set them to 2ch 16-bit integer and format at 44100Hz