Wilson Maxx 2


Anyone heard these and compared them to the originals? Curious what the specific sonic differences are compared to the originals, which I found somewhat interesting in many ways but ultimately flawed in comparison with most modern speakers of anywhere near their price range. Are they sensitive enough to be run with low powered SET's or do they crave higher power?
128x128Ag insider logo xs@2xowl
Karmapolice

The Rowland 302 were impressive on the Maxx 2's, I heard Halcro's on the original Maxx's.

I own Lamm M1.1s (not many of those owners either) that I use with my WP7... It's a magical Combination... I have a Rowland Synergy IIi Preamp that is now running on DC (no more power cords)
It's interesting to read all these comments started by a listen to my home system. Thx Cyto.
The Maxx-1 was very good until I heard the Maxx-2. The Series 2 has better integration of the drivers, faster, and better resolution of the silence between the notes. More control and slam in the bass with more extension too.
Each generation of Wilson's gets better, more musical (which is more accurate) and more fun to listen to for hours on end (if I only had the time!)
Only one correction- the amps are Rowland 301's not 302. The 302 is the stereo version, these are mono. How do they sound? Quick, fast, even, and controlled throughout the range. Incredible dynamics and pace. Solid bass and control. Smooth and articulate highs. Wide and deep soundstage. What more could one ask for from a power amp? Lower price?! Try the 201's, a bargain priced version with 250wpc into 8ohms and similar sonic signature and don't fare too badly on the Maxx's. The 301's and derivatives are probably the best sounding amps Jeff has done yet. The 301's are seemingly unlimited in power on the Maxx (either series)too.
And just to be on the up and up- I am an authorized dealer for Wilson, Rowland, Vandersteen and more.
Bottom line for anyone owning a pair of Maxx-1: upgrade NOW. Don't wait, there is no sonic negative, only positives. Onward, upward, and forward to audio nirvana!
BTW- the initial question was: are the Maxx Series 2 sensitive enough for an SET amp? I'd say so but haven't tried one IMS. Specs call out an 8ohm nominal with a 3ohm minimum; 92 db@1W (2.83V) @ 1meter. Factory minimum power amp size: 7 Watts!
If your SET amp is equipped with an XLR input, email me and we can arrange a listen in Scottsdale using your amp(s).