joeatlas

Responses from joeatlas

Luxman PD-272
Hi,I realize that this is a 3 month+ blog but I can help you with your dilemma. I have a PD-270 that had the same problem. If you open up the bottom you will see a small electronic board under to pots. On the board there are two or three small spi... 
My Turntable Collection.....
Morgenholz,I just came across your discussion on turntables. I too own some vintage tables (Dual, Denon, Pioneer,Yamaha, Technics, etc.} I am presently looking for a classic Kenwood 500, 600, or 650 to put with a beautiful Accuphase E-202 (made by... 
Personal speaker evolution
Hi,I seemed to work backwards toward vintage speakers over the years. I like the warm full sound and good bang for the buck. Currently still have the Infinite Slopes, Heresy's, ADS 810's, Ohm Walsh 2's and JBL L-112's. 1972- XAM speakers1975- Crit... 
Accuphase E-202 Integrated Power Up Noise
Neil, Thank you for your response. My unit started to cycle through like yours then one just would not turn on. I had suspected all along that it would need recapping and you helped verify the On/Off relay issue. Thanks again, this amp is definite... 
B&W DM6, any good compared to speakers today?
Thank You Pdn, These speakers were first introduced in the late seventies, evidently it was the first speaker to have a Kevlar midrange. They have a dedicated following and are supposed to sound very musical. I was wondering if anyone has ever hea... 
Best place to connect phono preamp to Fisher 500C?
Thank you everyone for all of the excellent information! It never ceases to amaze me how much knowledge can be found in these forums. I ended up buying a seperate phono preamp and have found the gain to be excellent. Thanks again! 
Best place to connect phono preamp to Fisher 500C?
I have a 4 pin DIN to RCA phono cable. I am a little unclear where to plug into the Fisher. I have been told to use the tape out on the Fisher. A little nervous, don't want to short anything out. Getting confusing, may just go with my original ide... 
Best place to connect phono preamp to Fisher 500C?
Thank you for your response. The Linn presently has a Trak cartridge which doesn't work with any of the inputs. I also have an original Naim setup that was purchased with the Linn. It is a NAP250 amp, NAC 42 passive preamp, and Snaps power supply.... 
How to use Naim NAC32 and Snaps with tube amp?
mpatnodeThank you for the information. I made up a 4pin DIN to phono cable and gave it a try. Worked like a charm! Do you have any suggestions for a good entry level phono stage that has enough gain for a moving coil cartridge? I was told that the...