2. amps-preamps
  3. 1047328911

3 Dedicated lines into 1

I had three dedicated lines run from my main panel when my basement was finished. I am still getting some hum even after putting in cable ground loop break and plugging all my components (other than main amp) into a Monster power conditioner. All of these helped but I think the remaining noise is because the amp and Monster are on different circuits. Does anyone think combining these circuits to be on the same line would help? I know very little about power but it seems that I have read that this could be causing my problem.

I have also thought that having a seperate ground put in and putting all three of my dedicated lines on it might have a good result. Any thoughts on this?

Thanks
bundy
jsawhitlock
302 posts
 
First thing to do is take the monster out and plug all componets into dedicated lines, then take a cheater plug and use on amp only, should solve your problem and if it does reconnect everything back into monster.
Cheater plugs are crap so a better thing to do is to modify a dedicated power cord for amp. most of the time it's one componet that cause the hum so you may need to swap the cheater plug around until you find the componet thats causing the hum but most likely it's the amp.
Good Luck!
bundy OP
127 posts
 
Jsawhitlock,

Is it safe to float the ground on a huge amp?

Anyone?
jsawhitlock
302 posts
 
Yes, it would be the same as a cheater plug, as I have to do this with a Acurus amp 250 watts. I have multi acurus amps in my HT set up and they all hum so I droped the ground on the power cords and all quiet now, so much better than the crappy cheater plugs!
Another thing to do is check out your sub panels ground, take a volt tester and see if you have any voltage on the ground, may be something leaking voltage and causing hum. I had a Audio research LS-3 preamp that gave me hum so I dropped the ground and no hum.
Only drop the grounds on eq. that hums.
Good luck!
lazarus28
339 posts
 
so wait - do you just clip the ground off of it with a pair of bolt-cutters?
polara
72 posts
 
this is f-n funny-i put in 2 more(1 already) dedicated lines sunday to try and solve a loop issue.one mono amp still sang a tune like this -hummmmmmm-well i grabbed a cheater plug out of the junk cabinet and now i'm finished.
called the amp builder and he said cheater plug was ok.
how long does it take new breakers, outlets and 12 ga wire (12 ft run) to break in --lol-- i noticed my sub amp likes its new home over the old line that it shared with lights and stuff.
More to discover