4 ohm vs 8 ohm taps

.
inpepinnovations@aol.com...An 8ohm speaker on the 8 ohm tap, and a 4 ohm speaker on the 4 ohm tap will look the same to the tubes driving the primary. (That's why different taps are provided). If the 8 ohm speaker is on the 4 ohm tap or the 4 ohm speaker is on the 8 ohm tap the tubes will see an impedance that is not what the amp designer wanted. Whether this will be enough to cause significant distortion, and if so, how much, is a question I will leave to the amp designers like Atmaspere.
.

Eldartford, this is where we disagree. If the 'wrong' ohm speaker is attached to the wrong tap, the tubes DO NOT see a different impedence at the primary. The tubes continue to see the primary winding impedence, whose impedence remains constant regardless of what impedence speaker is attached to whatever tap. The power transfer from the transformer to the speaker, however, is affected and also the distortion because of the mismatch of impedence on the secondary windings to the speaker. Due to this mismatch of power, the volume might not be sufficient and the operator then increases the gain at the tubes, perhaps driving them into distortion, but it is not because of the impedence changing on the primary side.
Salut, Bob P.

inpepinnovations@aol.com...You say quite plainly, "The tubes continue to see the primary winding impedence, whose impedence remains constant regardless of what impedence speaker is attached to whatever tap". It is not a question of misunderstanding. You are wrong.

How do you explain the MC phono pickup step up transformer example?

No, Eldartford, the person saying that attaching an 8 ohm speaker to the 4 ohm tap will cause distortion because the tubes will 'see' a different impedence than if the speaker were attached to the 8 ohm tap, is wrong! When in doubt, use the lower tap, the worse that will happen is a loss of ultimate power transfer, but with lower distortion.
Respectfully, Bob P.

inpepinnovations@aol.com...Have a nice day.