I agree w/Mceljo. If your system sounds good as is, leave well enough alone and save your coin. But if you need something new, I say look at one brand's lower-end models to keep cost down. Mixing and matching is just opening the door to a whole lot of wasted time and second guessing, IMO.
A good start on selecting cables?
Hello there in audio-land.
I am really having difficulty in selecting cables for my current system. It's time to upgrade as it's been years since I touched anything on it when it comes to wires.
The system runs McIntosh MC275 (two of them and may sell one in the future so I may or may not mono/bi-amp), McIntosh MC220 pre-amp, Rega P9 and a series of speakers, to which I will have to play with to determine which ones I keep. Infinity Reference 6's, Magneplanar III's, and Martin Logan Aerius's, oh and an older Paradigm self-powered sub.
In going through the list I was wondering about interconnects for the components and then speaker wires. XLR's, Coaxial or bare wires? After reading and researching many discussions on this I am more confused than I was originally.
I do want to start out simple, and inexpensive (say $500 - $1000) for all wires and see where I go from there.
Any advice, what do you use or what is your experience with certain cables/wires/connections would be very helpful.
Thanks and I do appreciate any comments.
I am really having difficulty in selecting cables for my current system. It's time to upgrade as it's been years since I touched anything on it when it comes to wires.
The system runs McIntosh MC275 (two of them and may sell one in the future so I may or may not mono/bi-amp), McIntosh MC220 pre-amp, Rega P9 and a series of speakers, to which I will have to play with to determine which ones I keep. Infinity Reference 6's, Magneplanar III's, and Martin Logan Aerius's, oh and an older Paradigm self-powered sub.
In going through the list I was wondering about interconnects for the components and then speaker wires. XLR's, Coaxial or bare wires? After reading and researching many discussions on this I am more confused than I was originally.
I do want to start out simple, and inexpensive (say $500 - $1000) for all wires and see where I go from there.
Any advice, what do you use or what is your experience with certain cables/wires/connections would be very helpful.
Thanks and I do appreciate any comments.
- ...
- 15 posts total
- 15 posts total