2. analog
  3. 152714-1640

A Worthwhile Untrasonic Cleaner

I just purchased these two items from Amazon (PRIME)...

An Album Rotation device - holds 5 albums...
https://www.amazon.ca/dp/B07PNCVMZ3/ref=pe_3034960_236394800_TE_dp_1

An Utransonic Cleaning Tub
https://www.amazon.ca/dp/B07HNQ26WT/ref=pe_3034960_236394800_TE_dp_f1

The rotation device is extremely well built and fits the tub perfectly. The tub also looks well made, but is a bit noisy, but that is normal from what I have read..

I have just finished cleaning some 30+ albums and found the complete unit is extremely good at getting rid of those crackles and pops - even finger prints and other grunge - with minimal effort

The tub defaults to a wash time of 5 minute (I used 10 minutes) and I reduced default temperature to 20 Celsius, but the ultrasonic process warms the water up, so by the time I had finished some 35+ albums it was 30 Celsius.

Even had a friend come over with 3 of his dirtiest albums - grunge + finger prints - just plain grubby. Ten minutes of cleaning and voila - shiney like new (apart from the scratches) playing the album was almost noise free - probably needed a second wash.

So the total cost for both units was around $450 from Amazon.ca ($370 from Amazon.com)) for the two pieces - which from what I have been seeing is perhaps the lowest price for an Ultrasonic cleaner out there.

Eager to try the unit that arrived yesterday, I only used distilled water - without any additive

What additive does the absolute best job ?
What difference does it make?
Or should I just stick with distilled water?

Thanks for any feedback.

One of the best analogue related value for money products I have ever purchased

At this rate I’ll clean my entire vinyl library pretty quickly AND do some of the wife’s jewellery :-)

If you are looking for something that actually cleans you vinyl well - consider these products.

Regards - Steve



.
williewonka
sammmmmmy
89 posts
 
Thanks Antinn.
Very informative.

I found you have to be careful with the Photoflow. Too much in the mix and anything left in the grooves dries so that as the needle passes it shaves off what looks like soap!

Anyways, if you stick to two/three drops per liter, you are okay.
uberwaltz's avatar
uberwaltz
13,381 posts
 
I have been using approx quarter cap into the whole tank capacity, 10 liters or so.
Not had any nasty residue to deal with.
Not sure as I have noticed it inducing hard treble....
antinn
395 posts
 
All,

If interested, I use a manual cleaning procedure using the VinylStack label protector.  I use Alconox Liquinox in 1 wt% solution to pre-clean using the Record Doctor nylon brush. Then rinse under flowing tap water assisted with the nylon brush,  Then final clean with Tergitol 15-S-9 in a 0.05 to 0.1 wt% solution with the nylon brush.  Then first rinse under flowing tap water assisted with the nylon brush, and then final rinse with DI water.  

The Alconox Liquinox is a Industry Standard (for many years) broad based cleaner formulated with anionic and non-ionic surfactants.  The Tergitol is only non-ionic, and the low concentration will achieve very low surface tension so it will penetrate the groove for the final clean and also remove any residue from the higher concentration Alconox Liquinox that may have not been removed.  

A bit of trivia, anionic and non-ionic surfactants are soluble.  Cationic and non-ionic surfactants are soluble (example Hepastat 256).  But anionic and cationic surfactants are not soluble and will form a paste type precipitate/residue. 
More to discover