AC Power - two circuits better than one?

Many thanks Elizabeth & Jea48, I will check this out tomorrow. Assuming I can find a second branch circuit fed from the same leg as the 20 amp circuit, I will likely connect the monoblocks (& possibly the power amp) to the 20 amp circuit & the sources to a 15 amp circuit. Does this make sense?

As predicted, apparently not all 3 branch circuits are on the same leg. Unfortunately, the configuration of outlets in the room on the same leg isn't exactly convenient. Hence my next question: If I keep all the audio components on a single leg (20amp & 15 amp), is it a major problem to have video equip (TV & DVR) on another leg - the only connection between the two systems is via HDMI routed through the preamp. I understand this isn't ideal but if they are attached to separate surge protection is it workable?

If this was me and rewiring is not an option, I would look into getting a power distribution center such as a PS Audio Premier and plugging into the one 20-A outlet and seeing if all my gear can be accommodated. It is always better, IMO, to limit the number of audio outlets to as few as practical to reduce ground loops and EMI/RFI.

If one power center isn't enough (monoblock amp draw, e.g.) then I would look to get another power center or an A/V grade power strip and plug it into the outlet without computers or motors on the circuit.

The advantage here is that you don't have to worry about phase leg anomalies (etc) because the power generators will scrub the power input.

But if rewiring is not an option due to cost, then my suggestion makes no economic sense because you can rewire for a lot less than the cost of one PS Audio Premier, let alone two.

Thanks again for your input folks! I will endeavor to load as much as I can onto the 20amp outlet & the remainder onto the 15amp outlet. The difficulty is just physical connection - too many things for too few outlets (in the wrong places!). At a certain point daisy-chaining power strips - & running long power cords - starts to get problematic. That's why I was considering connecting the TV & DVR into the out of phase 15amp outlet.

I was planning on connecting the audio gear via a Monster AV2000 SS & the HT gear via a Monster HD3650. I would prefer to connect the mono blocks & power amp directly to the 20amp circuit via PS Audio duets to avoid the power limitation problems of surge protection/conditioning...