426hemicuda. that sounds very interesting what you accomplished with your Denon 103 plus cost effective. If you were living close by I’d like to see how you did that. I admire anyone with the skill level and. know how to accomplish something like that.
Dover- thank you for your explanations and offering alternative cartridges to consider. This is a difficult subject to understand for an end user not conversant with electronics. So I appreciate you taking the time to try and explain some things. I’ll research all the alternative cartridges you recommend.
Raul, I don’t know much about the nuts and bolts of electronics, but should be able to figure out with some help an appropriate higher end cartridge compatible with the rest of my system. At the least, t am trying to learn so I don’t make too bad a mistake, so bear with me.
I’ve somewhere between 1300 to 1500 vinyl albums. I haven’t counted them in years. It varies, but I usually divide my listening time about equally between vinyl and CD’s. I’ve considerably fewer CD’s but their all newer to my collection and easier to use, so they get more use per capita. I’ll generally play two or three albums or CD;s per day on average.
2channel- thanks for your input and sharing your journey through the cartridges you’ve owned. At this point maybe I should just be soliciting recommendations on cartridges that fit my price point ($3500 range) that would be compatible with my Luxman integrated amps specs and my VPI Classic 2 turntable. I’m a bit disappointed both the Paua and Van den Hul LO won’t work. Thanks for the link too. I’ll check it out.
Mike
I copied the specs from the Luxman manual below for anyone who might be following along and interested and trying to learn about this subject and the specs under discussion.
Luxman 507uX MkII Specifications
Rated output
|
110W + 110W (8Ω),
210W + 210W (4Ω)
|
Input sensitivity/input impedance
|
PHONO (MM): 2.5mV/47kΩ
PHONO (MC): 0.3mV/100Ω
LINE: 180mV/47kΩ
BAL.LINE: 180mV/55kΩ
MAIN-IN: 1.05V/47kΩ
|
Output voltage
|
REC OUT: 180mV, PRE-OUT: 1V
|
Frequency response
|
PHONO: 20Hz to 20kHz (±0.5dB)
LINE: 20Hz to 100kHz (within -3dB)
|
Total harmonic distortion
|
0.007% or less (8Ω, 1kHz)
0.08% or less (8Ω, 20Hz to 20kHz)
|
S/N ratio (IHF-A)
|
PHONO (MM): 91dB or more
PHONO (MC): 75dB or more
LINE: 105dB or more
|
Volume adjustment
|
New LECUA1000
|
Amplification circuit
|
ODNF 4.0
|
Output configuration
|
Bipolar 3-parallel push-pull
|
Damping factor
|
260
|
Max. amount of tone control
|
BASS: ±8dB at 100Hz
TREBLE: ±8dB at 10kHz
|
Power supply
|
230V~(50Hz) / 115V~(60Hz)
|
Power consumption
|
350W
86W (under no signal), 0.4W (standby)
|