Does the loudness vary in proportion to turning of the level screws?
Am I reaching the max power / amplitude of my Rotel RB-951 power amp?
I'm currently using a Rotel RB-951 power amp to run some vintage 3.8D Fuseliers. They are pretty beefy and require a 4 ohm load, with a range of 50-125 watts as far as I can tell (information is slim on these online).
However, with my Eskinsin bluetooth adaptor plugged directly into the amp, or using a Kenwood Kr3130's tuner plugged into the amp, I am only able to get up to a maximum of 70 decibels with the meter in between the speakers. The clipping indicator on the amp does not come on at any point.
Since I seem to have such a distinct cutoff in volume, regardless of the input method, I'm thinking that I must be reaching the power limit of my amplifier. Does that sound right?
The Rotel does not offer power specifications on 4 ohm loads (but it can do them, per the manual). At 8 ohms it's rated at 50w/ch continuous and 100 watts in bridged mono.
- ...
- 10 posts total
@gs5556 the levels screws do turn down the volume, but it does not go up past the limit I am at, leading me to believe that it is set to maximum. |
I looked at the specs for your amp... the high level setting has an input sensitivity of 775mV. The Kenwood receiver specs show a tuner output of 160mV. That's why the amp is not playing loud, the tuner's max output is -14dB lower than the voltage required to drive the amp to max power. I'll bet if you put a scope to the Eskinsi output to a 0dBFS test signal you will see the same thing -- an output voltage way lower than 775mV. |
Okay great! So I need to explore a way to play media through my amp that doesn't involve the kenwood or the eskinsin. I'm assuming through a media player such as a modern AVR I can connect to, a streamer such as bluesound (expensive!) or some or streaming option I don't know about yet. I'll start researching.. thanks!
|
- 10 posts total