That is a great suggestion, thanks mate. I was looking at the photos more too, and wondering if I should look into replacing the power lead too - not sure of any audible impact though. Thanks for having a look!
Amp Internal Wire
Hi Gents, has anyone have any experience with upgrading amp or preamp internal signal wire? Most older equipment seems to have thin maybe sometimes poor internal wiring. In the world of OFC/OCC/Sterling and even more exotic wire available these days, any experiments done using this internally on components swapping out the cheap?
Lots of discussion about doing this with speakers, but never with components I've seen. For instance, I am thinking about replacing copper 'appliance' wire in an old Bryston with 14awg sterling from the board to the speaker binding post board.
Any thoughts?
- ...
- 86 posts total
Man, I couldn’t believe my eyes when I saw it. Like double take, think, look again, then realize. It had to have been making contact, the leg was tightly up against the through hole/pad - but wow. I took a photo of that too, I should have posted. If I remember correctly, since I was mainly looking at the underside of the board, it was a negative lead - the positive was soldered properly. |
+1 @rickysnit |
- 86 posts total