Analog cables for TT

Yes yes, normal InterConnects (IC) but given the ultra low signal (0.23 mV), there should be some kinda special thing..
I would imagine that shielding is very important due to the faint signal going through, I dont think big copper conductors would be the best bet, probably very slim silver wire would be the best, I have seen people using from "medical" bare silver wire to garden hoses...
Anyone with good experience that can share?

The main difference is that because the signal is very much lower than the output of the CD player shielding is much more important. Unshielded interconnects can be used to very good effect with care on CD player outputs, but a turntable interconnect must be well shielded.

I think that you may have hit the nail on its head. Given the very low signal level coming from a moving coil cartridge, what works well in other applications may not work well for phono IC. Noise can also be a significant problem and shielding may in some instances be required. Likewise, the availability of a ground wire is often critical to avoid hum. Three cables that I highly recommend in order of increasing price: Hovland, Nordost Valhalla dedicated phono, and Siltech. The Siltech unfortunately is very expensive and takes forever to break in but is excellent as is the Valhalla. The Hovland is close to the other two and about one quarter of the price. I have not tried the top of the line Purist on phono but it should also be very good.

What arm, cartridge and phonostage are you using? These will impact what you can expect to hear with different cables.

It might be worth it to obtain some demo cables and swap them out so you can hear the differences for yourself.

Project TT, Project arm, Sumiko Blue Point Cartridge. TAD-150 Pre with phono...

Thanks,