2. amps-preamps
  3. 989539438

Are Monoblock s worth it?

Would like your collective Wisdom on the subject of Monoblocks. I have a single Odyssey Stratos and the cost to convert to Mono's are not that much additional. However, I do not play my existing system at very high levels and almost never turn the volume beyond half-way (normally around 11:00). Is this an advisable upgrade? I know that I theoretically should have more dynamic headroom, but I do not know how this translates into real world listening.

System:

Maggie SMGa (soon to be Newform R645's in next week or so)
Morrison Elad pre-amp
Cambridge Audio CD500-SE

Musical taste - 50% Classical Symphonic, 30% Classical instrumental and 20% rock/pop
sibelius
thetubeguy
1 posts
 
I heard the best way is to use two stereo amps (with same power rating) and connecting them in vertical bi-amp. This method was suggested to me by using two Sonic Frontier power 2 instead of a pair of power 3. May be someone can give more informations on this subject.
sedond
1,387 posts
 
sibelius, re-read the last paragraph of my prewious post for the benefits of wertically bi-amping, vs running monoblocs... ;~) basically, if ya got enuff power for yer low-pass driver/s from one channel of a stereo amp, i tink wertically bi-amping will give better results than monoblocs. ask klaus about the trade-offs, he'll be happy to discuss w/ewe...

doug s.

sqjudge
96 posts
 
A while back I was at a friends and we had the opportunity to use a second Aragon 8008BB. One was left channel and the other right using only one channel in each amp. The resulting stagewas bigger and more focused. The music flowed with ease. Based on this I would assume it could get better by using two amps an bi-amping. With one channel delivering the lower frequency current and the high frequency current in the 'other' channel there would be less opportunity of intermodulation distortion being produced. I have heard improvements in bi-wiring and a wire is probably more linear than an amplifier at this level of current and voltage.
sedond
1,387 posts
 
sqjudge, i assume that your friend's speakers didn't allow for biamping, but only had a single pair of binding posts?

doug s.

jim
418 posts
 
Any experiences regarding monoblocks on sub woofers (Kinergetics SW800 towers)? My main amp is dual mono (tubes), the only shared component is the negative feedback control. The manufacturer has actually sawed these puppies in half to prove that they perform the same whether in one chasis or two. I agree with all of the superlatives thrown at mono amps -- just wonderin whether they make as much of a difference on subs. Thanks.
More to discover