2. tech-talk
  3. 168969-97394

Arrange circuit breakers in panel

Hello
           I've been following the discussions on this forum for many years, first time I've posed a question. I am in the process of adding two more dedicated lines to my rig. I was wondering, has there been a consensus on the best location, within the main service panel, of the placement of the audio/video breakers? I realize load balancing will dictate space used, but I've read that folks will place double pole breakers at the top of panel (in my case Square D QO 200 amp main panel) and some prefer single pole breakers toward the top. Has anyone experimented, come up with a better arrangement of the breakers? As long as I have the panel open, thought I might try to squeak a little more SQ out of the rig. Thanks.
128x128crazyjoe
ditusa's avatar
ditusa
1,883 posts
 

@crazyjoe,
IMHO, I would run a 10/AWG BX/MC cable with solid copper core conductors from the breaker panel to a metal receptacle box. The metal sheathing on the BX/MC cable absorbs the (EF)) electric fields emitted by the wires and shunts it to ground. Now from panel to plug is shielded. The upside is low line noise and reduced antenna effect on AC power lines/branch circuits.
Downside BX/MC cable is pricier. I would run at least two dedicated 20 amp lines for audio. I have four in my audio rig. All four dedicated audio circuits are 250 volts 20 amps. With no noise or ground loops. Also, all four dedicated audio circuits are at the top of the breaker panel numbers 1-8. See the link below. Hope that helps. Mike                                                                                                                        https://healthybuildingscience.com/2013/01/15/residential-wiring-best/#:
 R
crazyjoe's avatar
crazyjoe OP
2 posts
 
@ditusa 
   Thanks for reply. I've already run Diamond 10/3 w/o ground I found in a small hardware store. I believe the spiral configuration is all the noise rejection I'll need, since I live in the sticks. Was more interested in the mapping out of the A/V breakers, whether their position in the panel, either top, close to entrance feed lines, or down towards bottom away from household double pole breakers might help in noise rejection. 
Thanks 
andrewcoates
6 posts
 
I just bought a Square D 100amp. It has six spaces to mount one main breaker and five double- or ten single-pole ones.
auxinput
2,920 posts
 
I would recommend making sure your "audio/video" breakers are definitely on the same pole.  In most standard US panels, the poles alternate on each sequential breaker position.  So you would have to "skip" a breaker location in between each audio/video breaker so that it's placed on the same leg/pole. 

A normal US 220V breaker takes two breaker slots/connections and uses both 110V poles in a push/pull configuration to produce the 220V.
More to discover