Audyssey XT Room Calibration help....


I am wondering why when calibrating all 8 seating positions with my Onkyo Pro SC-885 pre processor it calculates the distance to near perfect but the crossovers are so out of wack. Speakers are Paradigm Signature S1's,C1,ADP1's - EG: 120HZ for rears which are crossed over at 70HZ, 120HZ for center and crossed at 60HZ, and fronts at 90HZ which are crossed at 58HZ. Should I just put them at full range or leave the settings as is????

ALSO: When a new installed powercord(s), interconnect(s), speaker cord(s), or component is connected to your system and you have prior calibrations should you re-calibrate with the new addition???? Any help would be appreciated...

REHGARDS Bacardi
128x128bacardi
kal, if you ain't a cable guy then fine, but...the receiver generates the test tone which in turn travels through the speaker cables which then is reproduced by the speakers. it would stand to reason that, if one beleives cables make a difference in the sound of a system, then a change in cable would change the readings audysee takes on the test tones cuz they will "sound" different. yes? audysee reads frequency response, speaker loudness level, speed of the response, etc. cables can and do change these things. would you recalibrate if you changes speakers? same thing. IF you're a cable guy. anything behind that chain can't make a lick of difference.
btw, those are very informative threads kal linked to. definately read them. calibrate as many positions as possible.
Well, Uncertainsmile, you do raise the two possibilities that I accept. Either one believes the cables make a difference or one does not believe they do. How would that affect one's need to recalibrate?

If you do not believe, then there's certainly no reason to recalibrate.

If you do believe that the cables made an improvement, then why would you want Audyssey to compensate and correct the change wrought by the cables you just paid for?

So, you can have it either way. ;-)

Kal
dude, it calibrates for optimal response in your room. IF your cables change the response of your speakers then it affects audysee's readings and calibration adjustments. what makes you think that audysee would cancel any improvements made by a change in speaker cable. in theory it should ENHANCE any such changes, otherwise why use it? with that said, now that i think of it the signal sent to your sub via your sub cable would change if you switch cables, recalibrate then too. c'mon now, be reasonable.