Best bi-wire speaker cables under $1000

Purist Audio Musaeus!!!!

Sean,

Is it possible for Bi-wiring a speaker to cause an extra frequency dip? For Instance a 2-way might be crossed over
at 2800 would the Bi-wiring add a dip at 600 or so?

I hope the question makes sense? and i would appreciate
your reply.

Thanks,

Steve

Depending on the design of the speaker, the individual cables used and how the amplifier loads into the various combos, i wouldn't say it was impossible.

I'm guessing that this is what you experienced when you tried bi-wiring with no other changes being made at the same time ? Sean
>

Sean,

Yes im getting an unexpected dip (its actually at 800hz)
my in-room response is +/- 3db worst case.. above 80hz except for 2 spots one at 800hz and one at 2600hz. Now this is with the RS digital meter and 1/3 octave test CD. I have found the RS digital meter to be very unreliable. For instance I used the Infinity RAMBOS (better than 1/3 octave)
measurment and found the RS off by up to 5db on the bottom.
What i havent done is un-biwire and test again.

Thanks,

Steve

Sean,

Sorry for the mutated response on my last post.. I was running out the door to go get my son.

The most important thing i didnt mention is.. i have
never measured this system without bi-wire so i
dont know for sure.

Can i just unhook one of the sets of wires at the speakers
and re-install the jumpers to test? Or do i have to take
the 2nd set off at the amp also?

Thanks,

Steve