The Carbon Fiber sleeves are intended to cover the entire Cable length but not the plug or connector. Select the diameter and length to suit your cable or power cord and slip it over the existing jacket. Voila! Seal both ends with electrical tape. The Carbon Fiber sleeves are highly reflective to electromagnetic waves and fields and act as RFI/EMI shields. Carbon fiber is conductive so keep that in mind when using. You certainly don’t want any dangling fibers floating around. Carbon fiber shield by reflecting rf so I doubt there could be interference. Besides the plug and connectors aren’t covered with carbon fiber. Problem solved. Carbon fiber sheets are also available for draping over equipment, providing additional shielding.
Best DIY power cable. Why not make?
Ok perhaps I don't get it. You have hot, neutral, ground and connectors. I am looking for advise from those that have found the secret sauce in making power cables or at least those that have had great success. With all the quality cable and connectors why not make your own? I refuse to pay $2,000 plus for a power cable that would take a hour to build. I am seeking your guidance and suggestions. Thanks!
- ...
- 76 posts total
@Leezmaze - $10-30 may get you a 12 gauge extension cord - then you have to add plugs Like these https://www.ebay.com/itm/Vanguard-For-Audio-24K-Gold-Plated-IEC-connector-US-plug-C-120G-P-120G/1813... or these https://www.ebay.com/itm/pair-Rhodium-Plated-C-037-IEC-plug-P-037-US-mains-connector-for-power-cable... I just used a standard 12 gauge extension cords - good for Source components and smaller amps. The connectors actually make a significant difference Make sure you strip the outer sleeve and braid the three conductors. If you like you can finish off with some expandable nylon sleeve - it protects the conductors and looks a little nicer Straight 12 gauge with the sleeve intact will not yield much of an improvement (if any) over stock cables. Make sure you get the polarity correct. Regards |
- 76 posts total