2. cables
  3. 1356634202

Cables that are more enhanced than Acoustic Zen

I am needing to go into a biamp situation (solid state for woofers) and two sets for the top end - using a zero speltz impedance box in the chain (mid and highs - otl mono block tube amps) Since my current speaker wires are Acoustic Zen Satori shotgun bi-wires I will unfortunately need to move on and completely redo my speaker cables in my system.I might look at interconnects at the same time for addtional system synergy,

I've done a bit of reading in old threads but feel a new post for my current bi-amp situation would be appropriate

I really like the strengths of the Acoustic Zen speaker cables - I also have the original Matrix IIs. Tonally balanced - revealing yet warm, dynamic, good seperation of instruments and great soundstage both width and depth.

I play upright bass so reproducing the warm tones inherant to the instrument is critical

Some have said that Acoustic Zen sound a little grainy - I've heard elements of that on the interconnects, and swapped them out for Straightwire Crescendos, Purist Audio Aqueous 50th. The Crescendos may be just slightly veiled (very subtle) the PAD are very dark and lack a little dynamics but are tonally balanced (I hear their more expensive cables are not dark and lacking)

I haven't tried anything higher up the Acoustic Zen line. I usually stay away from silver - I am very sensitive to bright high freqencies (a few concussions along the way) -I have 16+k hearing. I've had Cardas golden cross but it wasn't dynamic enough and too warm.

Cables suggested were morrow, higher level pad,
The Nordost I've heard I didn't like. Clear Day I have never heard of. Anticables I didn't care for.

My equipment Galibrier Gavia (currently triplanar wiring), Doshi Aalap Preamp, audio research cd2, atma sphere ma-1 tube mono blocks to speltz zeros impedance converter, qsc bass amp, and Salk Soundscape 10 speakers,

What cables would you recommend that wouldn't be incredibly expensive and have a tonally balanced sound leaning to the warm side with great dynamics and soundstage?

I would need 10 ft runs to the bass drivers. Should I go shorter on the top end, and small lengths on the "jumpers" from the zeros to the speakers?

Morrow SP5's sound interesting

Anyone went from Acoustic Zen to another cable? Or higher up the AZ line?

Would like to stay under $1000 on a 10' pair
unless the next step up is jaw dropping
Obviously broken in used would be nice

Thanks

Tom
128x128audiotomb
almarg's avatar
Ag insider logo xs@2x
almarg
9,670 posts
 
Tom, FWIW my perspective on this is that by far the most important criterion in your cable selection process is likely to be the need to mitigate the differences I suspect you will encounter in tonality, coherence, etc., between the QSC amplifier and the Atmasphere amplifiers.

Therefore my suggestion is that before investing in any expensive speaker cables you assess the new configuration using whatever cables you can get your hands on inexpensively. Then determine what you need to accomplish sonically, to optimize coherence between those obviously very different amplifiers. Hopefully you would then be able to get suggestions that focus on your specific needs.

And to RW, I can't stop laughing :-) Thanks!

Regards,
-- Al
audiotomb's avatar
audiotomb OP
1,112 posts
 
Al

Good point on wiring up the amps and seeing the differences

The woofers are rolled off at 39 hz so hopefully it won't be a big issue

Anyone used Clear Day speaker wires?
tom6897's avatar
tom6897
1,484 posts
 
Audiotomb

I In my system I noticed that the Morrow cables were slightly less warm... more neutral, which is what I strive for. I found them to be faster and more transparent offering greater resolution to my system as a whole. Soundstage width and depth were also enhanced.
almarg's avatar
Ag insider logo xs@2x
almarg
9,670 posts
 
The woofers are rolled off at 39 hz so hopefully it won't be a big issue.
Hi Tom,

Not sure, then, that I understand what the configuration is that you will be going to. From the description of the SoundScape 10:
We had, for many years, loved the woofer used in our HT3’s. So when it came time to select a woofer for the SoundScape design, we turned to John Janowitz at Acoustic Elegance. John helped us design 10” and 12” woofers that provide the bass extension we desired along with the smooth upper end response, allowing us to cross to the midrange around 300Hz.
If I correctly understand what you are intending to do, the concern would be optimization of coherence in the area of that 300 Hz frequency. The 39 Hz rolloff has no relevance to that.

Regards,
-- Al
audiotomb's avatar
audiotomb OP
1,112 posts
 
AL

sorry I left off a decimal place
390 hz roll off

I wish speaker wire prices would leave off a decimal place
$500 would go a long way
More to discover