2. cables
  3. 1190626595

Cables under the rug.....

I have researched the topic with some vigor and know about almost all of my options regarding wiretracks, corner molding, etc.

My question is more fundamental: What do I do to bury cables at a door threshold. The room is carpeted...and I have traditionally cut the padding and tape(d) the wires down...and then carpeted over the lot.

I have a signifigant amount of cable---rgb, straightwire meastro interconnects, speaker cables (synergistic), and a few others...so there is a sh*#load of cables.....

I would prefer another method as, eventaully, the foot traffic will wear on the wires AT THE THRESHOLD.

I've got the rest of the run covered.

Thanks for your advice in advance.

Erik
yesfan
shadorne's avatar
Ag insider logo xs@2x
shadorne
7,477 posts
 
Why not do it through the wall properly...with receptacles? If you are handy with a giprock saw and a screwdriver you could make a neat job of it. As long as you are dealing with signal wires (no 120 VAC) you don't need an electrician. Just my two cents - I have done this several times. It ain't cheap but it looks professional.
nsgarch's avatar
nsgarch
2,524 posts
 
Is there a door at the "door threshold"? And what is the subfloor, wood or concrete? Also, what is the w-2-w carpet material, wool or synthetic? Does it have antistatic threads woven into it? These are all important with respect to deleterious effects on signal transfer. You don't have to worry about the RGB, and if you're running speaker cable that far, I assume it isn't to your main speakers? The critical one is the Maestro IC.

My solution to this issue is to cut a strip out of the carpet right under the (closed) door and install a low profile (about 1" of space underneath) aluminum 'saddle' threshold in the space (about 3-5 inches wide depending on the extrusion you choose) running the cables under the threshold. HD carries them in natural, black/bronze, and gold. Pick the best match for your carpet. You can also have them custom anodized or powdercoated to match your carpet exactly, but that starts to cost.;-)
.
jc51373
532 posts
 
Just don't mix low voltage and high voltage into the same raceway, where ever it ends up being.

If you have a basement just drill through the floor at the threshold, come up the other side of the Threshold and continue with Wiretracks around the room. Two holes seems to make more sense than modifying an entire threshold.

If no basement, then modify away, or.....Go up and around the Reveal of the door itself, which requires the casing be removed. Uhhgh! Not to mention longer cable runs.

My experience with my own HT install for my Pioneer Elite TV is that it is not easy, or cheap to get it done the right way. I personally refuse to own a flat panel on a stand, to me they belong hung on walls, and this take some creative thinking in some applications.

Good luck
More to discover