2. analog
  3. 147418-7

Cartridge issues need suggestions

I am having issues with my Transfiguration Proteus - the left channel is cutting out.  It starts with a strong center  image then in a few seconds it drifts to the right intermittently, almost like someone is turning the balance control very fast.  Then it stays far right but I still have faint output in the left channel and sometimes some feedback like the stylus is out of line. 

It is not my tubes in the phono section because I checked that with my backup and it does the same thing.  I have rechecked overhang, cantilever alignment with my protractor, VTF - nothing has changed.  The only thing I haven’t adjusted is anti-skate and haven’t since initial setup.  Azimuth is set on a Basis Vector 4.  I took it off and upon visual inspection the it looks ok - the cantilever is straight but it might have shifted slightly to the left.  I can’t be sure.

Anyone had this issue - I never have...thanks for any feedback!
pops
pops OP
2,275 posts
 
Larry, it does seem likely to be the coils based what I was hearing.

noromance, I took it off and reinstalled and no matter what I did the problem was not solvable.

thanks all for your responses.
noromance's avatar
noromance
9,908 posts
 
@pops Before you throw it out, you could try a trick we used do and that is to apply a hot soldering iron to the suspected pin.
pops OP
2,275 posts
 
Thanks for the suggestion, I will do that.
solypsa's avatar
solypsa
462 posts
 
Throwing away could be silly. Most good cart repair pros will asses its condition for free or low cost once you send it in...
pops OP
2,275 posts
 
Agreed solypsa, I did not take inna’s advice seriously.  I definitely plan to have it looked at when I get around to it. 
More to discover