Cartridge (other than Rega) with Rega RP10

The Lyra Delos was pure magic on my RP10 until my now ex GF broke the cantilever off while house sitting when I was away some time ago.
The rebuild was more than I paid for the Delos to begin with so I grabbed an Apheta 2 which is really quite good but the Lyra was really stunning on the RP10.

Did she become your ex because of the damage? Folks need to know.

If you know the mass of the arm then you can easily find compatible cartridge, just make sure the dynamic compliance of the cartridge measured at 10Hz and don't forget the mass of the cartridge and screws. Here is the article. I think it must be mid compliance and most likely the arm is mid mass. 

I have been using a Lyra Kleos on mine since day one. In advice from Jonathan Carr (Cart designer) I was able to acquire shims for 3.5mm  at the base of the tonearm. Mr Carr recommended 3.4mm but unless I have shims specially machined, which I may do someday, I figured .1 mm can’t be that crucial with varying LP thickness. 
Something to ponder should you decide on Lyra, I think they are all the same height. But I do find the Rega and Lyra work well together when set up correctly.  Years ago I had a Rega P25 and used a Benz Glider and traded to a Lyra LydianB and found the Lyra much more pleasing.
Good Luck