Clear audio professional or klaudio record cleaner

I received my shipment form Cattylink today - unfortunately they shipped me the wrong item, a CD player. I have a couple of emails into them trying to correct the matter but have yet to receive a reply, which from some deep digging on various internet sites is not uncommon behavior from them in a case like this.

So until further notice I will discourage anyone from proceeding doing business with this company.

Stay tuned, as soon as I hear from them I will update you all.

Peter

Well ZERO response from the folks at Cattylink, so I'd caution strongly about buying anything form theses folks. Some folks have been lucky and got what they have ordered but it appears that as soon as an issue is up the are non responsive - quite disappointing.

Anyone looking for a CD Player :-)

Amari Arcana CD1.0

Good Listening

Peter

A word of caution to anyone getting the RW600, make sure you try it out with some trashed LP for the first few washes.

Our group ordered a few RW600s, while most were fine, there was one unit that caused heat damage to the LP in the lead-in groove area.

Also, not sure whether this is the same case with Audio Desk / KL Audio, but a manual tug is required to start the LP turning with the RW600. I believe this has to do to the plastic lips (similar structure to the windshield wipers in cars) that hold the LP being too hard. It may get better when it soften with use.

saw this on youtube....RW600

https://www.youtube.com/watch?v=zxgHENO1I2M

I purchased a RW600 from eBay. $1399 plus shipping. Sent DHL and arrived at my door 3 days later.
I too need to start the record turning with a slight nudge. 
Someone on YouTube states these have no ultrasonic transducer. Seems to clean the record well, but I'll admit I do not see a transducer in the cleaning area. You can vary the length of the cleaning (not drying) cycle by holding in the red start button. More beeps = more cleaning time. The eBay seller did not know this, but the same person who states there's no ultrasonic cleaner in the unit told me this and it works.
The eBay seller states the factory told him the Ultrasonic frequency is 80 Hz. Presumably he meant 80 kHz.

I'd like to take mine apart and look for the ultrasonic transducers.
Does someone have a photo of the transducers in the Amari?