connect 2 different wire gauge to pos and neg speaker terminal

almarg wrote,

"now regarding,

Geoffkait 9-2-2017
One thing I will sign up to is that if anything is traveling down the conductor it’s photons, not electrons. Free free to concur with comment, concur without comment or non concur.

As I’ve stated on previous occasions, I agree fully that the energy of an electrical signal (or power) being conducted via wires is conducted at near light speed in the form of an electromagnetic wave that is comprised of photons. We’ll have to agree to disagree, however, as to whether those photons propagate within or outside of the conductor, aside from the very small fraction of the photons corresponding to the very small amount of energy that is absorbed by the resistance of the conductor and converted to heat.

>>>>Uh, I’ve already stated that it’s a tie. As indicated by the mathematical paper from the Journal of Physics on the dodgy subject of whether the energy of the signal is located outside or inside the conductor the energy is actually partly outside and partly inside. And the mathematics for that conclusion is provided in the first couple of paragraphs. Don’t tell me you didn’t read it. GASP

Drift velocity is average electron velocity since it is "net" axial velocity in one direction while electrons move in different directions.  

https://en.wikipedia.org/wiki/Drift_velocity

Al, Herman is right - electric current (electricity) is a flow of electric charge.  Current does not flow, current is - charge flows.  The same is true in the river - water flows and current is.  Unfortunately improper usage of "current flows" (instead of electricty flows) is so common, that I found myself using it.  Improper became common.

Geoffkait 9-2-2-2017
Uh, I’ve already stated that it’s a tie. As indicated by the mathematical paper from the Journal of Physics on the dodgy subject of whether the energy of the signal is located outside or inside the conductor the energy is actually partly outside and partly inside. And the mathematics for that conclusion is provided in the first couple of paragraphs. Don’t tell me you didn’t read it. GASP

Yes, I had read the paper you are referring to.  There is nothing in it that is inconsistent with what I have said.

If you'll notice, it deals with a hypothetical situation in which the wire ***is*** the load.  In other words, a single piece of "long" wire is connected directly across the terminals of a voltage source.  (The numerous references in the paper to the wire being "long" presumably imply that its resistance is high enough to limit the resulting, um, current, to an amount that can be provided by the voltage source, and that would not cause the wire to melt).

In that situation the Poynting Vector would point inward to the conductor, at all points along its length, as shown in Figure 1 of the paper.   The energy carrying photons would therefore enter the conductor, causing the conductor would heat up.  Note the references to energy flowing **into** "the cylinder," resulting in "Joule heating."  "The cylinder" referring to the geometry of the wire.  As the paper says:

The picture that emerges from these considerations is that the electromagnetic field around a current carrying wire is such that the energy dissipated in the wire is brought into it by the corresponding Poynting vector through each point of its surface.

That is all perfectly consistent with what I have said on the subject previously, assuming a more real world scenario involving low resistance wires conducting energy to a resistive load.  In that situation the electromagnetic wave, and the photons comprising it, travel outside the conductors, aside from (as I said in my previous post) "the very small fraction of the photons corresponding to the very small amount of energy that is absorbed by the resistance of the conductor and converted to heat."

Regards,
-- Al
  

Kijanki wrote,

Drift velocity is average electron velocity since it is "net" axial velocity in one direction while electrons move in different directions.

https://en.wikipedia.org/wiki/Drift_velocity

Fermi velocity (random) applies only to materials when no current is applied. As I stated previously the very low Drift Velocity indicates that electrons do not (rpt not) travel rapidly at any time in the conductor. If they did the net velocity or average velocity whatever would be much higher than the centimeter per hour velocity observed.

Pop quiz, if electrons are changing direction with alternating current, why is there a net velocity in one direction along the axis? Shouldn’t there be zero net velocity? And why is the net electron velocity in one direction, not the other direction? Why do electrons favor one direction over the other, assuming vector of Drift Velocity is always in the same direction?