Difference between SET and push-pull using 300B

Can anyone explain the differences between SET and push-pull configures amplifiers using 300B output tubes? What does the majority prefer in terms of sonics?

I'm considering a pair of Zanden 9000s but just now realized that they were push-pull and not SET. I had an Art Audio Jota which was a SET and really liked the tonal quality -- just not sure how the 300B bould sound in push-pull configuration.

I appreciate your thoughts.
Nice thread. Is it critical to have a low impedance or low capacitance speaker cable connection to reduce the loss of dynamics or drive coming from an SET?

I am struggling with keeping my SET amp which has 6 small power supply banks so it never runs out of juice on peaks but I could not believe the authority a 7 watt PP Integrated with mickey mouse caps had over my speakers.

Theoretically it could be an issue and probably speaker cables with less capacitance should work better. But I had once on test at home SET 300B (Audiogon Silver Night) connected to my speakers with Kimber 8TC - which are known for relatively high capacitance - and it worked very well. No problems ...

I believe that the careful matching with the speakers is much more of an issue, when we are speaking about SET 300B, although (and that has to be said as well) they are capable of driving speakers that would never say that it is possible by just looking on speaker figures/numbers ...
High capacitance is not that strange in a speaker cable, as the capacitance contributes to lowering a quality known as characteristic impedance. When the characteristic impedance of a cable matches that of the speaker, you get a little more efficient power transmission from the amp due to less reflections.

How does copper or silver cables fit the equation when matching an SET amp to a speaker? My cables are non wire just foils so I hope they are low capacitance.
Interconnect and speaker cables are endless story. And there are many different opinions about it. And then silver vs. copper ... if we start that subject this post could last for years.

Therefore I will only tell you what I did and what I am doing ... All internal wiring within the pre-amp with Mundorf silver wire (0,5 mm). All inteconnects Crystal Cable silver wire (with 1% of gold). I am planning also to go for Crystal Cable speaker wire. All connectors WBT silver (on the pre-amp)etc.

So you can see that I am a fun of silver. But you should take care about several issues with silver. First, it is expencive. Second, if it is of low quality it can sound harsh, ... rough, ... unpleasently unrealistic. I was bought on Crystal Cable sound, though.

Therefore try by yourself, listen carefully and see for yourself whether it is something that you like. And whether you can hear the difference in your system, with your speakers, in your room. There are also some excellent sounding copper wires as well, so there is definitely no lack of choice in this area ... Take some time and compare them ... and you will see ... There is no clear and definitive answer, I think ...