DIY Helix Geometry Cabling

Acoustic Revive is the only route known to me to buy a Solid Wire.

The Red Sheath 0.9mm Solid Wire is the one used, where I showed the report from the Cable Producer.

The Big Cable producers such as Furutech and SAEC seem to have the monopoly on stranded Wire, but searches do discover Wire Only, usually ?? x 0.18 Strands.

My PC Triple C / EX is a Wire Clad with a High Purity Silver outer skin, which has a strand at 0.3mm and a Wire build up of ?? x 0.3mm. This is the Strand of Wire I intend on having used as my Tonearm Wand Wire. It might be the only Tonearm in use with this as a signal path.

I have been very reliably informed that there are renowned Cartridge Producing Companies that have used a 0.07mm - 41AWG Wire in a Model within their range Cartridges for the coil winding.

I have a 0.08mm PC Triple C wire that has been a very very difficult find.

Now I have 0.08mm Wire in my possession, it has prompted me to change direction on a Plan for a owned Cartridge to be rebuilt.

Off Topic Follows 

I am recently entered into a new discussion with a Cartridge Builder about having their design for a Cartridge produced with the 0.08mm wire as the Coil. It is early days, and obviously I will be taking all responsibility for the end result.

If all does come to fruition, there will to my knowledge, be the first PC Triple C Coil Wire Cartridge in use. 

The other designs I have in mind for this Cart' and working these ideas with how the Cartridge Builder has produced the design for their Cart'.

Leaves me to discuss the magnet material type, as there are three types available to be selected.

Cantilever and Styli are available in a selection of configurations, inclusive of a Glochid + Stylus.

The Skirt and Flange to be produced to enable the fastening of  the Cart' when mounting and additionally protect the Inner Cavity of the Cart' from the ambient world, is leaning towards a Panzerholz Form to function as this part. It will be a duplicate in dimension of the part already designed.

I am also knowing an individual who renovates Samurai Ceremonial Armour, he is  trained in Japan for using Urushi Lacquer. I was once offered his support to coat another Cartridge with Urushi Lacquer. Who knows I might also end up with what might be the first Panzerholz / Urushi Lacquer Cartridge. Would the Koetsu Family have approved of such a plaguerism. 

I had an idea how to secure all cable runs in my situation using a half round wood moulding and using a router to cut grooves for the strands. Red is signal, black is neutral. Width is 2" and height is 1"

@total111 , that should work with minimal induced noise.

Let us know how it works out.

I have to ask, can the amps be positioned closer to the speakers?

Might be easier to make longer helix interconnects and keep the speaker cables to a minimum length

Regards

Ah, very interesting idea, just the amps around the speakers....hmmm...let me think about that idea ;-) 

This room, while fantastic and large is however also a living room (with a wife and she does not really like this whole thing...). But yes, I want my music where I sit the most and not in a dedicated room ;-) 

How long can interconnects get? I was always under the assumption as short as possible. But the amps have 12 transformers and hence some magnetic field meaning put it outside the reach of DAC and Preamp is not a bad idea...

However, I have also to protect any ICs from being trampled and fortify them in some way...

Plus power cables, however that should be rather easy...

@total1, do the amps have xlr inputs, that would make life simpler e.g. using standard xlr cables from Zavfino perhaps

Something to think about

Regards