2. speakers
  3. 162538-154953

Do speaker wires matter

I recently was given a pair of Mirage M1 speakers. All highs, mids and lows work but I don’t believe they sound like they should.

The tweeters are not giving the detailed highs. I am not sure if the mids and lows are where they should be.

i am currently using a vintage 2226b Marantz I just had restored. Impedance is 8 ohms and it only puts out 26 wpc. I know these speakers require A much more powerful amp. I’ve done a little research on this.

im wondering if the speakers could not sound as good because of the Marantz and/or also because of the speaker wires I’m currently using. I don’t know what gauge they are. They were given to me as well. Any advice would be greatly appreciated.

i did also find a Mirage technician in Canada who still repairs them if I’ll have to take that route. No turning back now 😊
em2music
em2music OP
13 posts
 
Berner- they’re in a carpeted finished basement. Ceilings are 6’10” with 2 ducts running across and covered with drywall at about 6’1” height l. The basement is about 40ft x 25 not sure of square footage. There is alot in the basement to interfere with the sound as well ie. Furniture, drum kit, DAW on desk with monitors etc... cluttered.  I do keep the speakers about 2 ft away from the wall. 

There is only 1 red and black on each speaker. 

I currently have my Marantz going into 2 JBL HLS810 bookshelf speakers and they sound much clearer than the Mirages in terms of hearing the highs.
lowrider57's avatar
lowrider57
5,417 posts
 
OP, what did your system sound like with your previous speaker cables?

You do have an amp/speaker mismatch but I'm curious.
em2music OP
13 posts
 
Lowrider - this is the first time I’ve hooked them up (both sets of speakers). I used the same speaker wires for both.
Post removed 
em2music OP
13 posts
 
Tvad- I do but they’re not putting out much. I literally have to press my ear up against them but I hear all 4 of them.
More to discover