Dreaming of a DIY 8W Class A amp designed by Nelson Pass?

Built one w my daughter last Christmas when she was home from college.Took us a couple of days, probably 14 hrs total, but I did a lot of talking. She had never soldered before. I've done some kits.
Her gift was the finished amp. Mine was the time together.
Sounds great for what it is. Had so much fun w the build, I got their "SS-2" pre/headohone amp. They work well together.
I hope others check them out.
Jay 

Is this DIY 8 watt amp a chip amp?  What about the Nelson Pass First Watt amps, are they chip amps too?

I'm looking for an inexpensive SS amp to go with my Museatex AVC-1 preamp.  I have a PP EL84 amp already but don't want to run tubes all the time and would like to be able to have a relatively low powered SS amp to compliment this.  The speakers are 90 db Castle Durham 900's that are rated for a 15-85 watt amp.  I normally prefer a class a/b/ab Mosfet amp.

Thanks in advance! 

Not chip- discreet transistors.
The sides of the chassis are large heat sinks-
Even so it gets pretty warm! (class A).
7 watts on a side, switch on back to convert to 14 watt monoblock, also set up for XLR input 14 w mono.

Good, as I'm not a huge fan of the chip amps.  I've owned at least 7-8 of them with different chips and while they all sound pretty amazing, in the end, they alll seem somewhat sterile and lifeless.  IMHO, they all need a tube preamp to warm them up

@robeswi

Thanks for the information!

I’m going to build a dual mono set.  The stereo version sounds great with a small wide band monitor I designed and built.  I think a dual mono set driving a pair of 8” wide band speakers in a larger room will be awesome.  The BK-20 Kit that @schwartz36 mentioned might be a solution.

It would be wonderful if we could share photos of our ACA builds.  I see some on the DIY site, but I’m sure there are more.