DYNAVECTOR XV1T - XV-1T VTF ??


Anybody have any suggestions what VTF I should use on this cartridge? I'm using an AYRE DPS turntable with the factory carbon fibre Willi Bauer tone arm. I need a VTF of 2.7 grams to really make this cartridge come alive. My VTA is about level with the record perhaps a little lower on the weight side.

I have about 30 hours on the cartridge..

Stresses me out! is 2.7g too heavy ?
vanderdm
I have an XV1-s. With the Tri-planar MkVII, Durand Talea and Telos tonearms, it sounded best with VTF between 1.83-1.95 gm, depending on the tonearm. I have experimented with the higher tracking forces advocated by some and IMO, the XV1-s sounded terrible at the higher VTF...

While the XV1-s can sound very good with a less than optimal set up, a lot of the magic of the cartridge happens when the set up is spot on. If you haven't done so already, invest in a great protractor and accurate scale. Most importantly, invest the time to nail the set up. The XV1-t is a great cartridge!
I agree with Syntax that a normal correction as a cart is broken in is almost always (never absolute) between 0.1 - 0.3 grams. I also agree with Jazdoc that my XV-1s on my tonearm is fantastic at 1.95 grams and dull and lifeless at 2.5 grams. It can very well be set up dependent so I agree a good protractor and VTF guage is imperative for those expensive carts of all makes. Locking it in is a must!
Thanks everyone for chiming in. I use the factory protractor that came with the TT (which is mated perfectly for the tonearm that comes with the table) Do you guys think an aftermarket protractor will do a better job?

As far as setup, I wore a hole in my listening chair from getting up, sitting down, getting up, sitting down, getting up, sitting down - for days on end! I think I have it dialed in pretty good.. I have detail coming out of this cartridge that I have never heard before. I'm certainly happy with the sound. If i take it back to 2.2g it sounds lifeless, no punch, less detail.. ( though at 2.7g everything is better but I do notice more surface noise from the record )
Oh, BTW I forgot to mention I had the XV-1s before this cart and it sounded best at 1.9g.. Weird or what?
Have you changed the loading on the XV-1t as it has a higher internal impedance.
I only have experience with the XV-1s which has an internal impedance of 6 ohms.
Also you could try increasing the effective mass of the arm some how and re-adjusting your tracking force.
What is the effective mass of your tonearm?