Ethernet patch panel and network switch question


Guys,

I have an ethernet patch panel in my office that I'm running ethernet to my Antipodes K40 music server.  I've been reading a lot about the NA EVO ethernet passive filter and am on the verge of pulling the trigger.  However, it seems that everyone recommends a network switch from the router.  My router is 2 floors down into the basement.  Do I need to run a switch from the patch panel on the wall to the ENO and then to the K40?  Do I need a switch at all?  TBH, I have no idea what the switch would do.  I'm asking b/c lots of folks are talking about the benefits of using a switch before the ENO.  Thanks.


Bill

wtb

You don't need to do any of this in my opinion. Is your system currently performing well as-is? What problem are you trying to solve? If you are happy with it just leave it alone as most of these suggestions from an IT standpoint are in no way going to improve the sound. Keep it simple as the more items you add the greater chance of introducing issues, distortion or more points of failure.

If you want to try a mod that actually may improve your streaming network, check out the following article in Absolute Sound:

How To Optimize Digital Streaming With Optical Fiber - Page 2 of 2 - The Absolute Sound

Having a fiber Ethernet connection between your network switch and steamer will eliminate any RF or eddy currents over a copper Ethernet patch cable. I have found this to work very well and is a low cost/high benefit mod.

 

I would also look at what brand and model router and switch you are using. On my network I am using Cisco SG350-20 switches which are intelligent or managed switches. Although harder to setup that a non-intelligent switch, have ports which can be setup for a direct fiber connection, they are typically higher quality and provide network statistics which can be used to monitor the health of you network environment. also take a look at what router you are using. There may be an opportunity to upgrade it as well depending on its age and quality level. 

Unless you need to connect other LAN components in your office (which need to communicate to each other), a network switch is likely ’overkill’ for your specific application (i.e. solely for the Antipodes K40).

However, if you are prioritizing sound quality improvements it may make a difference. Make sure you are using decent LAN cable from your basement’s router to the office. Hopefully you are doing that already. If you are not, then I recommend doing so first...before you start adding on passive filters, a switch, etc. [Note: go direct from the router (I'm assuming you have an extra LAN port on it) to the K40. In other words, do not run that cable via your patch panel]

@nmolnar ’s suggestion to look into a fiber optic solution is a good one.

There are many ways to approach this. I believe you will be able to improve your sound quality. One example, having a separate (dedicated) network for your music streaming (separate from your other home and office requirements).

THank you, gentlemen.  Unfortunately, running a separate LAN cable to the office for music isn't doable in this scenario.  If you're saying the ENO is a no-go, I will continue to enjoy my music as is.  It certainly sounds pretty damn good.  I was just hoping to improve upon it a bit.

 

Bill