Fluctuating volume in one channel: Part II


I posted a few days ago about my left channel volume fluctuating from time to time. I got advice saying that it was most likely either the tubes in the preamp or a bad solder joint on an interconnect.

I switched the tubes in the preamp from left to right and right to left and the problem stayed the same (left channel fluctuating). Then I switched the ICs between the preamp and the amp from right to left and left to right. The problem stayed the same (left channel still fluctuating).

I did not bother switching the ICs from the cd player to the preamp because the problem remains even if I listen from a different source.

What is next in line for me to test? If you would like to see the other thread, it can be found here:
http://forum.audiogon.com/cgi-bin/fr.pl?aamps&1087439704&openusid&zzKetchup&4&5#Ketchup
Forgive me for starting another thread, but I know old threads don't always get read.
ketchup
Ketchup,

thanks for your reply. Good to hear that everything worked out with Classe- it is nice to know that they stand behind the product!

In my case I am using the XLR inputs, not the RCA's. I suppose the input board/shields that you mention are common to both RCA and XLR. My units are 2 1/2 yrs old.

I'll be darned but the amp has been running great for the past 48 hours. As soon as it acts up again I will be giving Classe a call.

thanks, Bill
Just an update . . . I sent in my amps to Classe via my dealer, and just got them back. So far so good after one night of listening. Armin mentioned replacing the shield wires, and replacing a resistor and cap, which he said wouldn't affect the unit sonically. Everything is sounding great once again!

Bill
gnobber, that's great! i hope it wasn't too painful being without your amps for tha time. it sounds like the switched the same things in our amps for the same reasons... they must be very similar inside.
i'm glad they're working well again. enjoy some music!