Grounding cable gauge size

So I finally received the Russ Andrew Plug In Router. It was held up in customs for a week.

Anyway, I just connected it to chassis grounds, and then tried it to source grounding and finally to my Entreq box and DIY version.

At this point (about a few hours) I can say it does nothing.

ozzy

So to those who care, I have now found that using the Russ Andres device with my Entreq box seems to be the way to go. I am liking the increased depth of the soundstage.

I am also running it to my Niagara 7000 to the AC ground only.

ozzy

@ozzy thanks for the update.  I have a rf router box on order.  Can you provide more detail on how you have it wired to each component/ground box? Is your 7000 only connected to the router wall plug no ground boxes.  Are your speakers connected to the wall plug?  Thanks

tksteingraber,

I have my Entreq Silver Tellus connected to the (source) RCA’s to my Lumin X1 and JL CR-1 Crossover. No preamp is used.

The Entreq then is also connected to my very large DIY ground box (pictures on my systems page) which also connects my subs and amps via banana’s

The Russ Andrews unit is connected to my:

1. Niagara 7000 to a DIY AC plug (with just the ground connected).
2. Connected to my Entreq via Banana
3. Connected to my Lumin X1 chassis ground terminal on the separate power supply.

My speakers are connected to a couple of my DIY ground box(s) for speakers.

ozzy

Yesterday, I disconnected the Russ Andrews unit from the Entreq. I feel the music sounds better with the Russ Andrews unit connected to just my chassis ground. ie; Lumin X1 ground terminal and the AC ground into my Niagara 7000.

ozzy