2. tech-talk
  3. 149754-133784

Help with crossover capacitors

I am re-capping some Altec Lansing 890C Bolero speakers.  They have 6uf/50volt and 3uf/25 volt caps.  What will change if I use 5.6uf and 3.2 caps?  I can't find the exact 6uf and 3uf values.  Should I go a little bit higher on those values or lower?  Any suggestions?  I'm looking at Dayton, Mundorf or Jantzen caps but I'm open to suggestions.

dannybad
dannybad OP
20 posts
 
I would prefer to not have anything hyped but realistically it's all going to be a proper upgrade.  I will check the sale.  I thought the CSA's were more expensive than that, but I will order them now if they aren't.
dannybad OP
20 posts
 
The 5.6uf caps are not available.  Could I just use 2x 3uf caps in parallel to replace the 6uf caps?  Then I just order all caps of the same size.

dannybad OP
20 posts
 
And another question:  The resistors are 30ohm 15watt and 15ohm 10watt.  Mills makes both of these in 12 watt versions.  Will this work?
grannyring's avatar
grannyring
6,464 posts
 
Yes on the two 3uf caps.  Now you’re thinking! Yes, the Mills will work fine. 
dannybad OP
20 posts
 
Just ordered it.  Thanks.
More to discover