High performance electric outlets


I just moved into an apartment which has the weakest and most feeble outlets I have ever seen. There seems to be so much confusion and controversy about this subject that I have no idea where to start.

My apartment has the electric panel in the pantry closet, so I will be able to draw 220V for my ONEAC 3000W isolation transformer. The transformer has two 110V outlets and feeds all my system. I would also need two or three more outlets in a power strip next to my equipment.

Should I just get something like two of those orange Leviton Hospital Grade outlets from Home Depot ($11.00 each) to replace the ones in the isolation transformer or is it really worth to go the 'audio grade' route? If so, how can I make an educated decision?
psychicanimal
Be careful about Hubbell hosp. grade. My understanding is that for hospital purposes they have a treatment that is not good for audio applications. Hubbell has the same level of outlet without these treatments. Also I would check out FIM outlet they are excellent.
The cryo treated Hubbell outlet Jena Labs sells is a "semi custom" model not carried by Hubbel dealers (according to their WS). It is a mere $100 each.
My experience with outlets over the past year and a half or so leads me to believe that there is literally a truckload of misinformation or disinformation on receptacles out there. I have tried a number of outlets from various manufacturers, and the best stock outlets I used were Hubbell 8200/8300 hospital grade, although I did not use a stock Hubbell 5362. The Jena Labs is a stock Hubbell 5362 that is cryoed, and both the Hubbell 5362 and 8300 are available cryoed from Audio Excellence/World Power, for $55 and $60 respectively. I can say that the cryoed 5362 is substantially better than the stock 8300 (which is also the basis for the PS Audio receptacle) and believe me, I was very skeptical that there would be much improvement. I posted a review of this receptacle at Audio Asylum (in the cables section) and tried to post it here, but apparently it didn't go through. Haven't heard the FIM, and wasn't keen on the Pass & Seymour stock receptacle that the Acme is based on.
"My understanding is that for hospital purposes they have a treatment that is not good for audio applications."

Ksales......I don't mean to throw a wrench into the works, but this is not exactly correct. For the hospital grade outlets, Hubbell uses a different, and higher-impact resistant face material (rather than the nylon used on non-hospital grade products) and bright-nickel plates all the power contacts and metal strapping. The multi-layer plating insures the metal won't oxidize or corrode, especially in a medical environment.

Sonically (and I beta-tested these units with others), the 8300 and 5362 are *very, very* close. They are both quite musical, with an extended and smooth frequency response. The 5362 gives a "slightly" more laid-back or relaxed presentation, the 8300 a "slightly" more immediate (one customer described it as more 'intimate') presentation, as if you moved your listening chair a bit closer. Again, these differences are ones of subtlety, not night-and-day differences.

From my understanding, bright nickel plating is on a different level than standard nickel plating, about which many have thought to have sonic problems, and consequently, have labeled anything with nickel plating to be "bad". In the Hubbell's case, au contraire.

I hope this information helps.
Alan, thanks for the info. I personally found it very informative. Just a few more questions if you don't mind : )

Do you know what the physical differences between the 8300 and 5362 are ? Have you ever had an 8300 cryo'd ? If so, what were the differences ? Thanks again... Sean
>