2. analog
  3. 1206028363

How to clean Stubborn Records

I've been having trouble with a few LPs that just don't want to come clean. I've been able to reduce the crackle and pop, but there is still a decent amount of it, along with constant surface noise. This may just indicate that the albums are worn out, but I hear no distortion in loud passages, nor is there a lack of dynamic range. To clean the albums, I first apply a solution of 1 part rubbing alcohol, 2 parts distilled water, with a few drops of detergent. I then use a paint brush to do a little scrubbing (the bristles have been cut down to about 1.5 inches long to enable scrubbing). After that, I put the LP on a dish rack vertically and rinse off with steam. I repeat for the other side, then put it through my Spin-Clean unit to remove any left over residue. The record is then lightly wiped, then air dried.

Are there any suggestions here to help me remove even more of the crack and pop? The method I described does clear up sound clarity in the higher frequencies, but it seems like there is still dirt on the record, as if the cleaning process loosened the dirt, but didn't fully remove it. Would a vacuum dramatically improve this?
jwglista
oregon
828 posts
 
Nano,
Either 300 or 400.
Leica optics.

Again, it looked like cuts made by a knife, on both walls of the groove, in even intervals. My only explanation is that a stylus which was broken, or chipped, perhaps, or, completely broken off the tip of the cantilever and that the cantilever tip created the marks, or cuts.
kenyonbm
141 posts
 
I have observed, on what otherwise seem all but perfect records, a uniform pattern of tiny radial cracks on both sides.

My theory is that these are shrinkage cracks along flow lines and between flow zones from the pressing. If the puck of vinyl was not blended sufficiently or the record not "cooked" in the press long enough to completely melt adjacent zones it might crack this way as it cools.

PVC has a relatively high coefficient of expansion.

Further, perhaps these records are superficially in good condition because they where unlistenable or even returned as defective.

Oregon, are the "cuts" you describe on both sides of the record? I would take that a supporting this explanation.

Ken
r_f_sayles's avatar
r_f_sayles
872 posts
 
I once read somewhere about a guy who drained a can of tuna juice on his records and then let his cat lick them off!!! He reported excellent results when using tuna packed in spring water. ;^)

Just having a little fun.

Many old pressings are dynamic as hell and sound beautiful with exception to an over abundance of pesky surface noise. Unfortunately, it is (sometimes), what it is.

Have you considered that it may have to do with your decks bearing and/or its tonearm/cartridge set up? I know this idea will drive you crazy but since upgrading my platter bearing (overall improvement on all records) and then my cartridge (specific improvement on replay of old vinyl) surface noise wise, I have found we blame the records individually when (for me) more times than not, it is the inability of the deck to transcribe. I've listened to many decks with the same pressings over the years and found a world of difference in their ability to pull the music out of the surface noise.

In other words; lost in translation.

Happy Listening!
cohnaudio
28 posts
 
Can one of you guys let me know what you use to steam clean. Also, how do you avoid warping the album?
More to discover