2. amps-preamps
  3. 1330946136

Impedance Matching - Tube Amp/Speakers

Hi, I am not technical guy, so excuse my questions. This weekend my friend did check bias on my VTL ST-85, which I recently did buy, and he also measured my speakers Dunlavy SM-1. Multimeter showed him that they are 4 ohm spekares (althought, on paper, they should be 6 ohm). He told me that this is not good combination - 4 ohm speakers and tube amp. So, is it safe using VTL ST-85, or tube amps generally, with 4 ohms or 6 ohms speakers? I am really confused because I like sound, but also dont want damage my amp or speakers.
arzach
ahendler
416 posts
 
Just connect your speakers to the 4 ohm taps onyour amp. Will work fine. I use a VTL ST-85 to drive 4 ohm Maggie 3.6's with no problems
unsound
7,329 posts
 
Once again, Al offers excellent advice.
philjolet's avatar
philjolet
2,306 posts
 
It is worth mentioning that the impedance of the speaker will affect the sound and control the amplifier has.

You may notice a bit of extra bloom in the bass or loss of control.

Not a big concern but you could try the different outputs on the back of the amp (presuming they give you a choice) and use the one you like best.

fwiw...
larryi
3,992 posts
 
You should try the speaker with both the 4 ohm and 8 ohm tap to determine which sounds better. Using either is entirely "safe" in terms of not damaging gear.

The 4 ohm tap will deliver less power, but, it will increase the damping factor, something that may improve the frequency response (typically, tighter, better defined bass).
almarg's avatar
Ag insider logo xs@2x
almarg
9,670 posts
 
Guys, according to the Stereophile review linked to above there is only 1 output tap, "optimized" for 5 ohms, with power output being specified for 4 ohms. Some photos of the rear panel that can be found via Google's image search function appear to confirm that there is only 1 tap.

Unsound, thank you most kindly!

Regards,
-- Al
More to discover