Info Needed on ADS L1530s


Greetings Audiogoners:
I recently purchased a used pair of L1530s and would like to rebuild the crossovers and rewire them. The existing crossovers will not allow straight bi-wiring (full bandwith going to high and low frequency inputs). The back panel of the speakers specifically warn against sending frequencies below 400Hz to the high input. Does anyone know what, if any modification, I can make during the rebuild that will allow straight bi-wiring? I appreciate any assistance with this. Thank you. klccharter
klccharter
leave them as-is. Anything you do is only going to make things worse most likely, and ruin any long-term value they would have. They are not very common. They were set up for bi-Amping (with external crossover) which has far more merit as an idea, than any type of biwiring (which is essentially useless with these).

Fooling around with the Xover if you dont' know what you are doing is more likely to result in blown tweets and mids than anything else. Given that these dome mids and tweets are unique to the L1530 and L2030, and are no longer made and rarely avaialable used, blowing them would result in a useless pair of rare speakers.

-Ed
Ed sawyer gives great advice! I own a pair of these, and a a pair of 1590's, which are similar. Biamp them if you want a big improvement, but don't mess with the crossover. ADS made a C-2000 Biamp System Control specifically for the 1230/1530/2030. And these speakers are darned good used full range, as is.
Alan
Interestingly, I saw someone recently selling off some ADS stuff from NYC area. I think in that, they had a C2000 system. They definitely had a pair of PA1s, which are the factory biamp modules that screw into the back of the L1290/1590 and I think 1230/1530 systems. Quite rare, worth having.

FWIW, I've owned L1290's, M15s, CM7s but currently just the L300s (all a/d/s/), plus 2 pairs of Aerials (the speaker company run by Mike Kelly, who was the brains behind a/d/s/ when the L series were being produced).

The top of the **30 line is the legendary L2030, big, rare, not that pretty, but apparently excellent sounding and quite efficient (uncommon for a/d/s/)

-Ed
Thanks Ed and Sid. This is helpful. I guess I bit off more than I could chew. My objective is to squeeze the most out of this system. My concern is, given its 20+ years, whether it even peforms to specs. Not that I can hear anything but perfection. Also, this bi-amp thing would require specially made crossovers, would it not, if I didn't go with the C2000 unit. I'm running a Sonic Frontiers P2 for an amp, so the C2000 (I assume the C2000 has it own amplification and does not allow pass-thru to external amps) would be a step down in performance. This speaker could compete with and beat the best out there, even now. Thanks for all your advise, I'm glad I haven't taken them apart.
klccharter