I have a Classic 1 plugged into a tubed based system.
Nordost at half or less, can be found here on Agon.
Consider Frey or Heimdall.
Nordost at half or less, can be found here on Agon.
Consider Frey or Heimdall.
Interconnect cables for turntable
Last nights listening session was interrupted when one speaker went silent! The culprit was the wire had loosened from the RCA connector on that side of the table to phono preamp - not the first time this has happened. I have a mish-mash of interconnects - Cord, Monster, Blue Jeans, now I'm thinking I should replace the interconnects between the turntable and phono preamp, and also between the phone pre and the preamp.
My system: VPI Classic 3, Zesto Andros 1.2, ARC LS27
I'm not interested in spending multiple thousands of dollars, maybe a few hundred to a thousand or so. Anti Cables seem to be reasonably priced. What other brands should I consider?
- ...
- 29 posts total
In the days back the external turntable interconnects came with ground wire bonded as one stereo cable with 2 RCA ends at each end. The signal wires there are 26AWG or thinner. That is to say that dedicated wires for turntable with fine gauge should work. Having another set of VPI wires will be most reasonable. |
Check out Van den Hul! https://www.thecableco.com/Manufacturer/Van-den-Hul?gclid=CIXxyOHkptACFRJMDQodJ3YF4A |
@fundsgon For the love of everything aurally holy grab some Audioquest Colorados at music direct. They are 60% off!! I took advantage of the sale and have my entire system wired with them now! They have .5m. 1m. and 1.5 m. lengths available. I have a VPI Scout, with a Dynavector DV20X2, using a 1m. pair into my phono pre and then a .5m. pair into my line stage. Clean, clear and dynamic. A truly rare opportunity to "steal" some fine cables on an amazing closeout sale. https://www.musicdirect.com/equipment/audioquest-colorado-interconnects-pr |
- 29 posts total