2. cables
  3. 150728-122613

Interconnect Directionality

Have I lost my mind? I swear that I am hearing differences in the direction I hook up my interconnect cables between my preamp and power amp. These are custom built solid core silver cables with Eichmann bullet plugs. There is no shield so this is not a case where one end of the cable’s shield is grounded and the other isn’t. 

There are four ways ways to hook them up:
Right: Forward. Left: Forward. 
Right: Backward. Left: Backward
Right: Forward. Left: Backward
Right: Backward. Left: Forward. 

There is no difference in construction between forward and backward, but here are my observations:

When they are hooked up forward/backward there appears to be more airy-ness and what appears to be a slight phase difference. When hooked up forward/forward or backward/backward, the image seems more precise like they are more in phase. The difference between forward/forward and backward/backward is that one seems to push the soundstage back a little bit while the other brings it towards you more. 

What could possibly cause this? Does it have something to do with the way the wire is constructed and how the grains are made while drawn through a die? Am I imagining this? Have I completely lost my mind?
128x128mkgus
elliottbnewcombjr
5,311 posts
 
I am skeptical of many tweaks, based on my and other's listening to changes in my and my friend's systems, 

There might be initial 'errors' of construction/cable path, rectified by simply messing about (like wiggling a phone charger cord), or natural cleaning of jacks/cable ends contacts occurring during the reverse process, or, not a criticism but the real possibility of the Emperor's New Clothes factor, based primarily on the desire for results from personal involvement.

........................

http://douglas-self.com/ampins/pseudo/subjectv.htm

Subjectivism: "Cables are directional, and pass audio better in one direction than the other."

excerpt "Audio signals are AC. Cables cannot be directional any more than 2 + 2 can equal 5. Anyone prepared to believe this nonsense won't be capable of designing amplifiers, so there seems no point in further comment."

........................................

certainly not the final word, but something to consider, especially the AC factor.


Post removed 
geoffkait's avatar
geoffkait
23,365 posts
 
Exactly! There are two wires involved in AC, + and - for each channel. When the signal goes toward the speaker on one wire, the signal (current and voltage) travels in the opposite direction on the other wire and vise versa. So both + and - wires/cables must be controlled for directionality, such that the “good” direction is toward the speaker for both + and - wires.
millercarbon's avatar
millercarbon
12,531 posts
 
And how, pray tell, does the signal get from the amp to the speaker if it doesn't travel down the wire? Riddle me that one, Batman. I guess being "AC" it just magically appears wherever without having had to travel anywhere.

Simply amazing the extent some will go to remain in the dream state. Take the red pill. Wake up. The worst reality has in store for you has got to be better than suffering so much in ignorance- utter, complete and unremitting ignorance.

Go and listen! Please!
mkgus's avatar
mkgus OP
324 posts
 
Assuming cables do have a direction to them, it makes sense that I observed a slight difference in phase or some type of imbalance when hooked up right: forward and left: backward. Assuming you’ve identified the cable directions, is there any difference between forward and backward if both channels are one or the other? Was my observation of the soundstage moving closer or further away based in reality or was it a hallucination?
More to discover