@antinn thanks for your responses.
Reading the P60H operation manual was helpful. However, not having actually operated it is quite another. I learn much better by doing.
What I was responding to is that attempting to pause the machine every 30 seconds to switch the pump on & off during this initial auto frequency change mode would be futile and maybe even damaging to the machine. The other issue that I was (and still am) not clear on is whether or not this 20-minute cycle (i.e. 10 minutes of auto frequency change mode followed by 10 minutes of 80kHz only) can be programmed into the machine to run as a single cycle. Pausing the machine after this initial 10-minute auto frequency change mode in order to switch on the pump/filter for the 10-minute 80kHz cycle seems more feasible. However, it seems, to me, that it would be more practical to run these two operational cycles separately, rather than pausing the machine and activating the pump/filter at the 10-minute mark. This would obviate the need to standby and be alert to this while I'm doing other things (e.g. pre-cleaning additional records; etc.).
Thanks for the tip on the iSonic pump/filter! I wish I had known about that before purchasing the CleanerVinyl pump/filter. That would have saved me a good bit of coin.
Thanks, also, for the tip(s) on the record spinners! I've lately been taking a closer look at the Kuzma RD kit that Tima uses. However, I've only found two places in the USA that sell this and the price seems rather steep, in my opinion.
Thanks again and all the Best!