Krell KAV-500 vs S-1500 5 Channel & cables


Hi all,

Wondering if any of you have experience with both the older Krell KAV-500 5 and S-1500 7 channel amps? I read that the S-1500 had some problems (burn ups & hum) when first introduced.

I have a recently purchased/re-capped KAV-500 in my 7.2 HT. The rear surrounds are currently powered by 2 channels of the Marantz Cinema 60 processor.  Front speakers are B&W 804S Nautilus (L&R) and a HTM-1 Center.  Surrounds are 804 Nautilus (not S) and the rear surrounds are B&W SCM-1's on stands. There are 2 JL subs in front.  Cables & interconnects are a mix. Projector is a Sony vpl-5000es laser.

Rooms are combined open living room (13'x19' long, screen on the 19' wall) with "L" into 13'x'13' dining room with rear surrounds against back wall in DR 26' from front screen/electronics &. 20' cathedral ceiling over both.

Question: is it worth pursuing the more powerful used S-1500 or does it have the same sonic signature as the KAV-500? The KAV seems to have plenty of power but some dialog can sound "hollow" and slightly tipped up.  Also, there is some occasional HF distortion during musical passages on shows (not using it for 2 channel listening).

Cabling is single 25' run of Wireworld (not the top of the line can check model) to the surrounds and bi-wire (cables & interconnects we were going to manufacture) to the fronts & center. 14 gauge single long run generic wire to the rear surrounds.

Any input for sonic improvement would be appreciated. No room in cabinet for 2 amps (a 2 & a 3 channel). Won't go crazy$$ on cables/IC's if that's where to look. No dedicated lines yet and everything plugged into Richard Gray box except the amp.

Suggestions for sonic improvement appreciated.

Thanks.

 

 

 

 

 

 

tt1man

Lasers? "We don't need no stinking lasers" I'll just sit on the floor, but at my age might not be able to get back up. At which point I'll be remembering you and your suggestion ;-)

After this, I'll be experimenting with all copper interconnects and cabling (heavier gauge to the surrounds and possibly bi-wire as well), brands TBD including Cardas and even some low cost Monoprice, to see if in fact the silver is causing the nastiness.

OP:

Well, it was just a suggestion to get you to think about the angle of the speaker to your head.  Another possibility would be to put the speaker above the TV, or turn it upside down. 

Yes, actually the tweeter projection angle is a little low and I'll be elevating it a bit.  Projection screen's top valance is too high up on the wall to mount the center. More elevation plus proper wires should hopefully solve the problem.

The KAV seems to have plenty of power but some dialog can sound "hollow" and slightly tipped up. Also, there is some occasional HF distortion during musical passages on shows (not using it for 2 channel listening).

This reeks a bit of a degraded/faulty amp.

- Sell this "recapped"/used amp (that someone passed off to you, he must be breathing easy now) and cut your losses before it becomes more of a headache.

- Run the 4 surround channels off your Marantz.

- Get 3 Schiit Tyr monoblocks for your front stage (front main/center/right main). It should hit your rig with a rich dose of adrenalin and get you up to speed.

 

P.S. if you are a loyal Krell fan/insist on hanging on to it... move additional channels back to the Marantz and run only the 2 fronts with the Krell. See if it improves the sound, no hollow bass, distortion went away, etc.