Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
My LSA keeps getting better with time (I've had it less than a month), so I'm withholding final judgment until later. Definitely needs warm up use time to sound its best (the second side of a record, and beyond, always sounds better than the first side played).

That said, it delivers beautiful sounds right now and no way I would sell it. And, yes, George is a standup guy who is very quick to answer questions and delivers as promised.
Specs for TRL? Like asking Rolls Royce for horespower data and getting "sufficient" as a response. Just kidding, but their site offers very little information beyond price.
I believe the TRL amps are over 47k ohms, somewhere in the 65k ohm range, maybe higher.
Paul told me the TRL Samsons input impedance is 68kohms.

From my experiences with many Krells and Pass amps in the past using different tube preamps, there are NO impedance issues between the TRL Samson and LSA.
It would be good for someone to grab an ohm-meter and measure the input terminals (Amp off naturally).
If it is bipolar transistor input you can bet you life it's going to be less than 47k.
If it's fet transistor input there's a chance it's 47k, maybe higher.
If there is no reading or wavering all over the place it has capacitor coupled input (yuck and double yuck)
Cheers George