MC loading at 47K


Hi All,

Just after some expert advice from your good selves if I may. My current system is as follows:

Musical Fidelity KW550 intergrated amp which has a MM and MC section, both loaded at 47K. The only difference between them is the step up voltage.

My turntable is the Rega P9 with Ortofon Kontrapunkt A.

Looking at changing my cartridge but honestly cant decide between MM or MC.

My music taste are as follows:

Reggae
Soul
Female Vocal
RNB

No classical or jazz.

So what should I choose based I'm only limited to a 47K loading. I was thinking either of the below:

1. Ortofon Jubilee (MC)
2. Ortofon 2M black (MM)
3. Clear Audio Maestro (MM)

Is there a down side to loading up a MC so much?

Thoughts please...thanks
che13

Showing 4 responses by marakanetz

you might experience very thin sound and lack of holography.
the realistic load impedance to try is sub- 100Ohms. You can solder 100Ohms resistor in-parallel with 47K resistor or try different resistors using aligator clips.
The impedance of Benz Glider SH is more than 10x higher than Kontrapunkt A. If you try to load with 1.5k you might like it better.
Hifihvn,
It has 47K for both MC and MM. Not too many low output MC carts will benefit from being loaded @47k. I would connect a resistor in-parallel when switching to MC. It could be done in any phono unit.