MC402 vs FPB 300cx

Nwavesailor, I hear you...But I stand behind most of what I said about the Mac though. At the risk of this topic coming up again, the MC402 still sounded slow, etched, not smooth, predictable, no emotion and so on-in my system...I got a very good picture for the sonic signature of that amp regardless, and it just wasn't for me. Conversely, this Krell does everything I wanted it to outside of the sibilance I experienced before Cosecant, which I do believe I can resolve the small amount I have now.

At this point though you are right, in terms of the glare side-effect I experienced with the MAC, it most likely was my front end at the time.

Audphile1-you just reminded me I have to call them..The directions on the coupling caps were less than good. I lifted the hood on it last night and was hesitant to unplug what I thought were the jumpers they were instructing. Things just didn't match the sub-par instructions they provide to do this.

Do you still think I should go for it now? What the heck right? IF it will soften a little I would be willing to try it.

I would give it shot and see since it is just a matter of changing a jumper setting. If you had to solder a cap in, I would forget it. I hope Krell comes through for you.

Arthur

Jc51373, whatever you do, be careful. The caps cary some voltage. You may want to unplug the amp several hours in advance to discharge the caps before you do this.

Audphile1-you just answered a question I had in my head...I was wondering that last night when I was looking inside, if there could be residual electricity. I will be careful.

I will tell, ya is marvelous looking inside this thing, incredible engineering.