Try one MC150 for both Maggies, lowish volume and compare to the bridged sound. When I tried bridged Mac, it seemed a little more tight as opposed to relaxed. I prefer relaxed. Next try passive bi-amp. You'll like it one way more than another. We're all free to gamble. My bet would be on the passive bi-amp. Good luck.
McIntosh & Maggies - am I hooked-up the best way?
I recently upgraded my two channel system - after researching Audiogon and serious negotiations with my wife... Here's what I've got;
* 2 McIntosh MC150 amps set up as mono bridged (note I had one originally)
* McIntosh C712 pre amp (also part of my original system)
* Denon 3910 SACD player (with Underwood level 2 mods)
* Magnepan MG 3.6 speakers (with Mye Sound stands)
* MIT bi-wire speaker cables
* Monster power and interconnect cables through-out
* 2 Monster Power HTS5000 power centers (also have my HDTV, satellite HD reciever. D/A converter (now only used for the satellite audio), VCR and cassette deck in the mix, so I needed more plugs!)
* Audiopoints brass points under amps, preamp and speaker stands
The sound is awesome... (a;though my wife claims to not be able to tell the difference...) My question, "are my amps and speakers hooked-up the best way?", is because when I have the volume up, then crank up the bass and loudness on my pre amp, the amp power meter lights pulsate with the music. While this is not a bad looking effect - it concerns me that the power meter lamps are influenced at all. I know that Maggies will take all the power (current) they can - but that is why I'm using the MIT bi-wire speaker cable... any thoughts, comments or suggestions would be appreciated!
* 2 McIntosh MC150 amps set up as mono bridged (note I had one originally)
* McIntosh C712 pre amp (also part of my original system)
* Denon 3910 SACD player (with Underwood level 2 mods)
* Magnepan MG 3.6 speakers (with Mye Sound stands)
* MIT bi-wire speaker cables
* Monster power and interconnect cables through-out
* 2 Monster Power HTS5000 power centers (also have my HDTV, satellite HD reciever. D/A converter (now only used for the satellite audio), VCR and cassette deck in the mix, so I needed more plugs!)
* Audiopoints brass points under amps, preamp and speaker stands
The sound is awesome... (a;though my wife claims to not be able to tell the difference...) My question, "are my amps and speakers hooked-up the best way?", is because when I have the volume up, then crank up the bass and loudness on my pre amp, the amp power meter lights pulsate with the music. While this is not a bad looking effect - it concerns me that the power meter lamps are influenced at all. I know that Maggies will take all the power (current) they can - but that is why I'm using the MIT bi-wire speaker cable... any thoughts, comments or suggestions would be appreciated!
- ...
- 8 posts total
- 8 posts total