2. speakers
  3. 1032102494

Nautilus 805 setup question

Just got a pair of 805's and while fiddling around with placement, etc. I noticed that removing the grilles seems to improve clarity a little bit, but at the same time the speakers tend to reveal their position much easier; the soundstage is thus "distorted" left (speaker), right (speaker) and center become somehow "source points" instead of an evenly distributed soundstage in front of the listener. To make a long story short, the speakers don't "dissapear" so well anymore.
So is it grilles on or off? Similar experiences? any advice on tweaking/setup is also welcome.
Thanks
aboldor
aboldor OP
49 posts
 
Let me just add that my room is an "acoustic nightmare" - it always takes me a lot to set up my speakers acceptably, and even then it's not always perfect; the stands I use are cheap wood stands (had floorstanders 'till now, adequate stands are on their way) and finally, the differences I'm talking about are subtle - if this is not the right place to be paranoid about your system's sound, then which one is? :)
poorguy
90 posts
 
Taking the grilles off makes the tweeter look unlike a microphone. Another tweak makes N805 easier to drive for SET is temporarily taking out the woofer & adjusting the position of the foams inside so that the foams do not block the back wave of the woofer.
kchahoc
85 posts
 
I tighten down the woofer screws about every six mounts. How far apart do you have the speakers?
Keith
zaikesman
3,017 posts
 
"I tighten down the woofer screws about every six mounts (sic)" - Sounds vaguely like some sort of unatural sex act, don't it? ;^)
chazzbo
1,007 posts
 
Albodor
Not sure what stands you have on the way and if can reverse them back but call Bob Warzalla atSound Anchor and have him explain what went inot their design.He told me that he top mass loaded them as opposed more prettily and way more expensively B&W did when they bottom mass loaded them.All I know is that Bob knows more about some speakers than their actual manufacturer and B&W has been his bread and butter for years so he put's a huge amount of time and money into their design.While their are a number of good stand manufacturers out there like Target and Arcicci B&W and Sound Anchors well there is no other match.I even had a dealer THROW IN FOR FREE a pair of used ones for a pair of 802 Matrix III's after we had agreed on the speaker price (very good deal to begin with) as he told me he had forgotten to mention it and that he wouldn't want to have people hear my speakers and then they had come from his shop without the stands as that they dont' realize anwhere near there potential without them.Go to Sound Anchors web site and get numbe and talk to Bob if you have any questions but they are worth every penny and then some.
More to discover