2. digital
  3. 190000-159739

New DAC issues

I have been on a steady system upgrade path over the last year and one of the last pieces to be updated is my DAC, a Schiit Gungnir Multibit. I have no complaints with it, but I am always in search of more and better. The majority of my upgrades have been a big success.

I recently purchased a new DAC that shall remain unnamed, I don't want to throw it and the builder under the bus, but it is about a 5x multiple in cost over the Gungnir. I have had the new DAC for four days now, and I have been playing it continuously. When I installed it, I simply unplugged the other DAC and substituted this one, so minimal change. Initial impressions were that it sounded pretty lean and the soundstage was not great, but I figured it would sound better after warming up. There has been some improvement, but it is not significant.

Playing music with the Gungnir in place, bass was plentiful without being overbearing, and very clean. With the new DAC, bass is almost an afterthought. The Gungnir presented a beautiful soundstage and my speakers disappeared. The new DAC presents a good center image, though smaller than the Gungnir, and the speakers are pretty apparent on most tracks. In general, the magic is gone from the music, there is detail in the mids and highs, but not a lot of life.

I expected a different sound of course, but I cannot imagine that this is the way a DAC at this level is supposed to sound. I think that the Gungnir is considered a warmer DAC, but the contrast in this case is extreme. I am wondering if there is either an issue with the unit or somehow a mismatch with my gear. It provides a 3V output vs the Gungnir's 4V, which may make it a little less lively, but 3V is not out of the ordinary.

The rest of my systems is Pass XP-12 -> Coda #8 -> KEF Reference 1. I am in between streamers right now and using my DigiOne/Pi with LPS over RCA SP/DIF. One could question the streamer, but it sounds great with the Gungnir. I had an Aurender N10, but I did not get along with the Conductor software and now have an Innuos Zenith on the way. Connections are all balanced with Wireworld Eclipse 8's, Acoustic Zen speaker cables and an Acoustic Zen digital cable. Power is dedicated and runs through a Furman Elite 20.

I listen mostly to jazz and lower levels and I have always had a full sound, however with the new DAC the system is no longer engaging. Thoughts? Can a DAC just be incredibly lean?

 

 

zlone
audphile1's avatar
audphile1
4,891 posts
 

Also if you have an aftermarket power cord on the new dac, go back to stock cord to get a baseline. If you used the same cord on Schiit and new dac it’s possible there’s no synergy with that cord.

gdnrbob
4,444 posts
 

Though your new DAC might need to be 'burnt in', I think it telling that you didn't notice a significant upgrade from you Schitt Gungy.

I went from the Bifrost to Gungnir and heard a definite improvement in sound quality. I also had the Ayre Codex, which was very close to the Yggy.

My final jump was to the Brinkmann Nyquist II. In every change, I noticed the sound quality improved, no questions asked.

So, IMHO, if you don't find this new DAC smoking the last one, it might be a reason to look to another brand.

Note:

I noticed that your streamer might be changing to Innuos, which happens to be my streamer. I think you should wait and see if the Innuos improves upon the sound. Streamers can make a huge difference, too.

B

audioman58's avatar
audioman58
4,129 posts
 

Any good dac will take about 300 hours to show its true character.

and always leave it on unless all tube

the T+A200 is the go to dac reference quality that can be had for under $7k ,by many that competes with anything at 2 x it’s cost pretty well.

with a very good resistive ladder preamp section. The digital front end is the most important part of the system since all music starts here and once sonics are produced can’t be fixed down stream. The Loudspeaker too is very close in most important component .

mitch2
3,961 posts
 

Can a DAC just be incredibly lean?

Yup, it can, and some people will like it, but horses for courses.

Buying high priced gear, with positive reviews, from a well-respected manufacturer is not a guarantee that you are going to like how it sounds in your system.  By all means, give it a week or so to burn in and then, instead of convincing yourself to keep it, return it or sell it, and go find something that sounds good to you.

mikhailark
241 posts
 

DACs sound vastly differently depending on the chip they use (or being R2R without chip) as well as filter implementations. If it doesn’t sound right to you it does not mean its bad. I personally know that most probably I will not like DAC based on ESS but will like AKM or Burr-Brown. But it does not mean ESS is bad. Just not to my taste.

Also, make sure you ARE getting an upgrade rather than just paying more for brand name. Say, you are getting ESS 9038 over 9018 and not the same (or lower!) chip.

My DAC is now R2R which is the best IMO.

More to discover